665980
2
Zoom out
Zoom in
Previous page
1/10
Next page
NLFD
I
Empfänger Batterieinstallation
Schieben Sie die Batteriefach-
abdeckung auf der Rückseite
nach unten und legen Sie die
Batterien ein (nicht im Liefer-
umfang enthalten) 2 x 1,5 Volt
LR14 / Baby.
Beim Einlegen bitte auf Polarität
achten!
Schieben Sie die Batteriefach-
abdeckung des Empfängers
wieder ein. Der Empfänger ist
nun betriebsbereit.
Empfänger Befestigung
Der Empfänger hat auf der
Rückseite ein Befestigungsloch.
Dadurch kann das Gerät an
einer Schraube aufgehangen oder
jederzeit beliebig in einen anderen
Raum mitgenommen werden.
Das Befestigungsmaterial
(Dübel und Schraube) ist im
Lieferumfang enthalten.
Achten Sie bei der Montage
darauf, daß zwischen Wand und
Empfänger ein Abstand von ca.
3mm gelassen wird, damit das
Gerät locker eingehangen
werden kann.
Installatie batterij ontvanger
Schuif het deksel van het
batterijvakje aan de achterkant
naar onder en plaats de batterijen
(niet meegeleverd) 2 x 1,5 Volt
LR14 / baby.
Let op de juiste plaatsing van de
polen!
Schuif het deksel van het
batterijvakje van de ontvanger
weer terug op zijn plaats. De
ontvanger is nu klaar voor
gebruik.
Bevestiging ontvanger
De ontvanger heeft ter
bevestiging een gat aan de
achterkant.
Het apparaat kan aan het gat aan
een schroef worden opgehangen
of met de clip worden bevestigd
en meegenomen naar een andere
kamer.
Het bevestigingsmateriaal (plug
en schroef) is meegeleverd.
Let er bij de montage op om
tussen de wand en de ontvanger
een afstand van ca. 3mm over te
laten om het apparaat
gemakkelijk te kunnen ophangen.
Installazione delle batterie nel
ricevitore
Spingere il coperchio del vano
portabatterie sul lato posteriore
verso il basso e inserire le batterie
(non contenuto nel volume di
consegna) 2 x 1,5 Volt LR14 /
Baby.
Durante l’inserimento prestare
attenzione alla polarità!
Inserire nuovamente il coperchio
del vano porta-batterie del
ricevitore. A questo punto il
ricevitore è pronto per il
funzionamento.
Fissaggio del ricevitore
Sul lato posteriore del ricevitore
è presente un foro di fissaggio.
In tal modo l’apparecchio può
essere appeso ad una vite o
essere portato in qualsiasi altro
ambiente.
Il materiale di fissaggio (tassello
e vite) è contenuto nel volume
di consegna.
Durante il montaggio lasciare
una distanza di circa 3mm tra
la parete e il ricevitore, affinché
l’apparecchio possa essere
appeso in maniera lasca.
Bell+FlashFlashBell
Mise en place des piles dans le
récepteur
Faites glisser le couvercle du
compartiment des piles (au dos
de l’appareil) vers le bas et
mettez les piles en place (pas
comprises dans la livraison)
2 x 1,5 Volt LR14 / Baby.
Respectez la polarité lors de la
mise en place!
Remettez le couvercle du
compartiment des piles en place.
Le récepteur est alors prêt à
l’emploi.
Fixation du récepteur
Le récepteur dispose d’un trou
de fixation sur son dos.
Ainsi, il est possible d’accrocher
l’appareil à une vis ou de
l’emmener au gré dans une
autre pièce.
Le matériel de fixation (vis et
cheville) est compris dans la
livraison.
Lors du montage, veillez à laisser
un écart de 3 mm environ entre
le mur et le récepteur afin de
pouvoir accrocher facilement
l’appareil.
Code Setting
Switch
Kodierschalter
2


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Heidemann 70384 - HX Flash at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Heidemann 70384 - HX Flash in the language / languages: German, Dutch, French, Italian as an attachment in your email.

The manual is 0,24 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Heidemann 70384 - HX Flash

Heidemann 70384 - HX Flash User Manual - English - 10 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info