665923
2
Zoom out
Zoom in
Previous page
1/6
Next page
Sender-Batterieinstallation
Der Sender wird durch eine
3 Volt Lithium CR2032 Batterie
betrieben, welche im
Lieferumfang enthalten und
bereits eingelegt ist. Entfernen
Sie lediglich die
Schutzfolie,welche seitlich aus
dem Sender herausschaut, so
dass ein elektrischer Kontakt
hergestellt wird.
Um die Batterie zu wechseln,
entfernen Sie zunächst die
Oberseite des Senders durch
vorsichtiges Drehen des Sender-
Oberteiles nach links. Tauschen
Sie die alte Batterie aus.
Überprüfen Sie, ob die Batterie
gemäß der angegebenen
Polarität (+ = oben) richtig
eingelegt ist. Setzen Sie die
Rück- und Vorderseite des
Senders wieder zusammen. Der
Sender
ist nun betriebsbereit.
Befestigung der Halterung
Sie können die beiden
vorgestanzten Löcher auf der
Rückseite der Halterung als
Schablone verwenden, um die
Bohrlöcher zu markieren.
Die passenden Dübel und
Schrauben sind im Lieferumfang
enthalten. Alternativ kann die
Halterung auch mit einem Klebe-
sockel befestigt werden, der
ebenfalls im Lieferumfang enthalten
ist.
Wichtig
Durch Montieren des Senders auf
weichmacherfreie PVC Türrahmen
oder Metalloberflächen, wird die
Reichweite eingeschränkt!
Battery Installation of Transmitter
The transmitter is operated by a
3 Volt Lithium CR2032 batteries,
which is included in delivery and
is pre-installed inside the
transmitter. Just remove the
protective foil sticking out from
the side of transmitter, which will
establish an electrical contact.
To change the battery, first
remove the top of the transmitter
by carefully turning the upper
part of the transmitter to the left
(anti-clockwise). Replace the
old battery.
Please check if the battery is
inserted correctly according to
the polarity (+ = up).
Reassemble the back and front
of the transmitter. The transmitter
is now ready for operation.
Mounting the Bracket
Both pre-cut holes on the back
of the bracket can be used as a
template to mark the drilling
holes.
The respective wallplugs and
screws are included in delivery.
Alternatively the bracket can
be fixed with an adhesive base,
which is also included in
delivery.
Important
When mounting the transmitter
on rigid PVC door frames or
metal surfaces the range
will be limited!
Instalacija baterije oddajnika
Oddajnik poganja 3 voltna litijeva
baterija CR2032, ki je vsebovana
v obsegu dobave in že vložena.
Odstranite samo zaščitno folijo, ki
ob strani gleda ven iz oddajnika,
tako da se vzpostavi električni
kontakt.
Za menjavanje baterije najprej
odstranite vrhnjo stran oddajnika,
tako da zgornji del oddajnika
previdno zavrtite v levo. Staro
baterijo zamenjajte.
Prekontrolirajte, ali je baterija v
skladu z navedeno polarizacijo (+
= zgoraj) pravilno vstavljena.
Hrbtno in sprednjo stran oddajnika
zopet sestavite. Oddajnik je sedaj
pripravljen za uporabo.
Pritrditev držala
Obe predhodno narejeni luknji na
hrbtni strani držala lahko uporabite
kot šablono za označevanje vrtin.
Ustrezni zatiči in vijaki so
vsebovani v obsegu dobave.
Alternativno se lahko držalo pritrdi
s pomočjo lepilnega podnožja, ki
je prav tako vsebovano v obsegu
dobave.
Pomembno
Z montažo oddajnika na vratne
okvirje, izdelane iz PVC-ja brez
mehčal, ali na kovinske površine,
se domet omeji!
SLOGBD
HR
Sehr geehrte Kundin, sehr
geehrter Kunde.
Vielen Dank, dass Sie sich
für den Kauf dieses Heidemann
Produktes entschieden haben. Es
gilt die gesetzliche
Gewährlestungsfrist. Von dieser
Gewährleistungsfrist
ausgeschlossen sind Defekte, die
durch unsachgemäße
Behandlung, nicht
bestimmungsgemäßer
Verwendung, oder Missachtung
der Bedienungs- und Installatons-
anleitung eingetreten sind.
Allgemeines
Beim Betätigen des Klingeltasters
(Sender) wird ein Signal an den
Empfänger gesendet, welches
diesen aktiviert. Die gewünschte
Melodie ertönt.
Strahlwasserschutz
Der Sender ist IP 55 Strahl-
wassergeschützt. Bitte
vergewissern Sie sich vor
Gebrauch, dass das Oberteil
korrekt und fest mit dem
Unterteil verschraubt ist!
Dear customer,
thank you for choosing this
Heidemann product. The legal
requirements for the terms of
warranty apply. Defects, which
are caused by inappropriate
handling, use of device for
another as the intended purpose,
or disregard of the oper ation and
installation instructions, are
excluded from the terms of
warranty.
General Information
When pressing the bell
push-button (transmitter) a signal
is transmitted to the receiver
which activates it. The requested
melody sounds.
Protection Against Water Jets
The transmitter is protected
against water jets in compliance
with IP 55. Before use, please
check that the upper part is
correctly and securely screwed
onto the lower part!
Ugradnja baterija u odašiljač
Odašiljač pokreće 3-voltna litijeva
CR2032 baterija koja je
obuhvaćena isporukom i već je
umetnuta. Samo uklonite zaštitnu
foliju koja bočno strši iz odašiljača
kako biste uspostavili električni
kontakt.
Kako biste zamijenili bateriju,
najprije opreznim okretanjem
gornjega dijela odašiljača ulijevo
uklonite gornju stranu odašiljača.
Zamijenite staru bateriju.
Provjerite je li baterija pravilno
umetnuta u skladu s navedenim
polaritetom (+ = gore). Ponovno
sastavite stražnju i prednju stranu
odašiljača. Odašiljač je sada
spreman za rad.
Pričvršćivanje držača
Obje izrezane rupe na stražnjoj
strani držača možete koristiti kao
šablonu za označavanje rupa za
bušenje. Prikladni moždanici i vijci
priloženi su. Alternativno držač
možete također pričvrstiti pomoću
ljepljivog postolja koje je također
priloženo.
Važno
Montiranjem odašiljača na PVC
okvire vrata bez omekšivača ili
metalne površine ograničuje se
domet!
2


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Heidemann 70371 - HX Maxi at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Heidemann 70371 - HX Maxi in the language / languages: English as an attachment in your email.

The manual is 0,21 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Heidemann 70371 - HX Maxi

Heidemann 70371 - HX Maxi User Manual - German, Dutch, French, Italian - 6 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info