502645

Harman Kardon AVR40 Manual

20
Zoom out
Zoom in
Previous page
1/24
Next page
Operation
To some ears the impact of the wrap cir-
cuit may seem subtle, and this is normal.
Remember that how audible the wrap
effect will be varies with the acoustics of
your listening room, the output settings
established during the calibration process,
the system volume and the type of pro-
gram material in use.
Note that the Wrap circuit is not in use
when the Wrap Indicator
˜
displays
the two lights connected by the REF
bar along with the center, front and
middle LED.
When the Wrap buttons
ˆo
are
pressed when the AVR40 is in the Hall
mode, the circuits are adjusting a con-
trolled amount of level into the rear
channels. The amount of this change
will be indicated in the Information
Display. Note that the range of control
for the Wrap circuit in the Hall mode
will vary depending on other system
settings, and you may find that the
setting cannot be adjusted below a
“+4dB” indication.
Tuner Operation
The AVR40’s tuner is capable of tuning
AM, FM and FM Stereo broadcast sta-
tions. Stations may be tuned manually,
or they may be stored as favorite station
presets and recalled from a 30 position
memory.
Station Selection
1. Press the AM/FM button
6d
to
select the tuner as an input.
2. Press the AM/FM button
6d
again
to switch between AM and FM so that the
desired frequency band is selected.
3. Press the Tuning Mode button
¸
to
select manual or automatic tuning.
When the AUTO indicator is illuminated
in the main information display the
tuner will only stop at those stations that
have a strong enough signal to be
received with acceptable quality.
If the AUTO indicator is NOT illumin-
ated, the tuner is in a manual mode and
will stop at each frequency increment in
the selected band.
4. To select stations from the front panel
press the Tuning button
Ú
. When
AUTO indicator is illuminated each press
will cause the tuner to search for the next
highest or lowest frequency station that
has an acceptable signal. When tuning
FM stations in the auto mode, the tuner
will only select Stereo stations. To tune to
the next station, press the button again.
If the AUTO indicator is NOT illuminat-
ed, tap the Tuning button
Ú
to advance
one frequency increment at a time, or
press and hold it to locate a specific sta-
tion. When the TUNED indicator illumi-
nates the station is properly tuned and
should be heard with clarity. To listen to
the station in stereo, press the Tuning
Mode button
¸
until the red STEREO
indicator illuminates in the front panel
display.
5. To select stations using the remote,
press the Manual Tune
››
/
‹‹
buttons
h
to select stations one at a time. After
an FM station is selected, the Tuning
Mode button must be pressed to receive
the station in stereo, when available.
Alternatively, the Automatic Tune
››
/
‹‹
buttons
i
may be used to
scan only those stations with sufficient
strength for proper reception. Each press
of these buttons will advance the tuner to
the next station. For stereo reception
press the Tuning Mode button
¸
until
the STEREO indicator is illuminated.
NOTE: When the FM reception of a
station is weak, audio quality will be
increased by switching to mono mode by
pressing the Tuning Mode button
¸
until the STEREO indicator goes out.
17
AVR40 rev (j) 4/16/97
Ref
Wrap
Ref
Wrap
Ref
Wrap
A) When the Wrap indicator appears in
the “Reference” position, the special Wrap
circuits are not being used and the unit is
in the pure Pro Logic mode.
B) This display appears when the
maximum Wrap is applied.
C) This display appears in the “Phantom”
mode or when a center channel speaker
is not installed.
•AVR40 om (j).qx 9/15/98 3:47 PM Page 17
… 20 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Harman Kardon AVR40 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Harman Kardon AVR40 in the language / languages: English as an attachment in your email.

The manual is 0,73 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info