640739
1
Zoom out
Zoom in
Previous page
1/2
Next page
-J03893 REV. 2005-08-10
FLHTCUSE HEATED SEAT KIT
GENERAL
Kit Number
51718-06
Models
This kit fits 1997 and later FLHT/I (Electra Glide
®
Standard),
FLHTC/I (Electra Glide Classic) and FLHTCUI (Ultra Classic
®
Electra Glide), and 1998 and later FLTR/I (Road Glide
®
)
models.
Additional Parts Required
If another accessory is already using the accessory circuit
connector [4] (under the seat, see Figure 1), the Heated Seat
Kit will require a Switched Circuit Adapter Harness (Part No.
70264-94A), available separately from a Harley-Davidson
dealer.
Electrical Overload
It is possible to overload your motorcycle's charging
system by adding too many electrical accessories. If your
combined electrical accessories operating at any one time
consume more electrical current than your vehicle's
charging system can produce, the electrical consumption
can discharge the battery and cause vehicle electrical
system damage. See a Harley-Davidson dealer for advice
about the amount of current consumed by additional
electrical accessories, or for necessary wiring changes.
(00211b)
When installing any electrical accessory, be certain not
to exceed the maximum amperage rating of the fuse or
circuit breaker protecting the affected circuit being modi-
fied. Exceeding the maximum amperage can lead to elec-
trical failures, which could result in death or serious injury.
(00310a)
The Heated Seat requires up to 4.2 Amps additional current
from the electrical system.
Kit Contents
Table 1. Kit Contents
Part NumberDescription (Quantity)
Not Sold SeparatelyHeated seat
51479-06Grab strap
INSTALLATION
1. For 2006 and later FLHT/I/C/CI/CUI, and ALL FLTR
models:
a. Follow the instructions in the Owner's Manual to
remove the left-side and right-side saddlebags
b. Remove the bolts and flat washers to remove the
passenger grab strap and saddlebag front mounting
brackets from the chrome frame tube covers.
c. Remove the passenger grab strap.
2. ALL models: Follow the instructions in the Owner's
Manual to remove the seat.
To prevent accidental vehicle start-up, which could cause
death or serious injury, disconnect negative (-) battery
cable before proceeding. (00048a)
3. Follow the instructions in the Owner's Manual to remove
the negative (-) battery cable from the battery.
4. See Figure 1. Identify and remove the plug from the
accessory circuit connector [4] in front of the battery.
is01034
Figure 1. Accessory Circuit Connector [4] (2004 and Later
Shown)
5. Locate the heated seat connector on the underside of the
heated seat.
-J03893 1 of 2
1


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Harley-Davidson J03893 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Harley-Davidson J03893 in the language / languages: English as an attachment in your email.

The manual is 0,17 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info