607450
4
Zoom out
Zoom in
Previous page
1/15
Next page
6
7
To view the barometric pressure measurement, press Ω repeatedly until the pressure reading appears.
To change the pressure unit, hold Ω to enter setting mode. Press Ω repeatedly to skip the clock & calendar setting until
the pressure unit ashes. Press or to select. Press Ω to confirm and exit.
12/24hr format > Hr > Min > Yr > D/M or M/D format > Month > Date > Pressure Unit > EXIT
Radio-controlled clock
The unit will start synchronizing the clock after battery installation or reset. In normal mode, press [ / ] until
icon appears to enforce searching of radio-controlled clock signal. If the icon disappears afterwards, radio time signal
is not available at the moment. Try other locations later. Place the unit away from source of interference such as mobile
phones, appliances, TV etc.
Antenna icon with full signal strength will appear on screen if the reception of radio-controlled time is successful.
The radio-controlled clock will have a daily synchronization at around 02:03 and 03:03 everyday. Each reception cycle is
minimum 2.5 minutes and maximum 10 minutes.
In/out temperature & humidity
Press [C/F] button to select temperature unit C/ F.
Press [CH] button to select Ch1, Ch2, Ch3 and auto-channel scrolling display modes.
Maximum/minimum memory
Press [MEM] button repeatedly to view the maximum & minimum values of temperature & humidity readings. To clear
the memory record, hold [MEM] button while the respective values are displaying on screen.
Clock & calendar
Press Ω to toggle display between time, calendar, day of the week & pressure reading
Hold Ω button to enter clock setting mode. Using or to adjust and Ω to confirm, the following values can be set in
sequence:
12/24hr format > Hr > Min > Yr > D/M or M/D format > Month > Date > Pressure unit > EXIT
Home time, world (ZONE) time
Hold [ZONE] to enter world (zone) time setting mode. Press or to enter the desired hour offset value from –12 to
+12 hours. Press Ω to confirm and exit.
Press [ZONE] button to toggle between home (radio-controlled) time and world (zone) time. “ZONE” icon appears when
world (zone) time is selected. When zone time is not used, keep zone time to “0”.
Alarm setting
Press [AL] to show alarm time and “AL.” icon will appear. Press again to enable or disable the alarm. Bell icon
appears when alarm is enabled.
Hold [AL] to enter alarm time setting mode. Press or to enter the desired Hr/ Min values and press [AL] to confirm
setting.
Snooze
When alarm is going off, press [SNOOZE] to trigger snooze alarm. To stop alarm for one day, press [AL] key.
Low battery indication
Low battery indication is available for the home unit itself and all of the 3 remote channels. Replace the batteries and
follow the setup procedure in this instruction manual.
Battery disposal
Replace only with the same or equivalent type recommended by the manufacturer.
Please disposal of old, defective batteries in an environmentally friendly manner in accordance with the relevant
legislation.
Specifications
Indoor Temperature: 0 °C to + 50° C (+32 °F° to +122 °F)
In/Out Humidity: 20% - 99% RH
Remote sensor: -20°C to +60°C (-4°F to +140°F)
Channel: max. 3 remote sensors
Transmission: up to 30M in open area, RF434 MHz
RF reception cycle: around every 3 minutes
Resolution: 0.1 degree C for temperature, 1% for humidity
Clock: DCF77 Radio-Controlled, Quartz back-up
Power: CR2032 x 4 pcs for main unit
AAA x 2 pcs for remote sensor
Registration and Safety Certification/General Information
This device bears the CE symbol as specied by the provisions of Directive R & TTE (1999/5/EC).
Hama GmbH & Co. KG hereby declares that this device is in compliance with the basic requirements and other
relevant guideline and regulations of the 1999/5/EC guideline. You will nd the declaration of compliance and
declaration of conformity in the Internet at http://www.hama.com
4


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Hama EWS400 - 87688 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Hama EWS400 - 87688 in the language / languages: English, German, Dutch, French, Polish, Turkish as an attachment in your email.

The manual is 1,42 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info