564763
4
Zoom out
Zoom in
Previous page
1/6
Next page
4
The minimum dimensions are (see drawing):
D 50 cm
E 30 cm (from inner edge firebox opening).
Rückwand: rear wall Seitenwand: side wall
Unterlagsplatte: floor protector
Strahlungsbereich: radiation area
Floor protection slabs (support slabs) are available from our
accessories program and can be ordered from your specialist
stove dealer if required.
5. wood stove operation
The wood stove must only be heated by adults. Ensure that
children never stay alone around the chimney stove. (Do not
leave the wood stove without supervision for any length of
time). The wood stove must only be used in accordance with
this Operating Manual.
Please observe the safety instructions shown in Chapter 2.
5.1. Suitable fuels
The stove is suitable for low-smoke fuels. The fuels
approved for combustion are listed on the Equipment Sheet.
Note! Wood is not a slow-combustion fuel so that
continuous heating of the fireplace with wood overnight is
not possible.
Note:
Never use waste such as wallpaper, chipboard offcuts,
plastic materials or impregnated wood for heating!
5.2. Adjusting the combustion air damper
The correct setting of the combustion air damper of your
wood stove can be found in the enclosed Equipment Sheet.
Please adhere to these recommended settings to optimally
utilise the heating energy of the fuel, to save fuel and to
protect the environment.
Combustion air
1 = primary air I through the grate
2 = primare air II flows onto the fuel in a horizontal dir.
3 = secondary air / air wash system
pre-heated air from above is the main combustion
air for wood
5.3. Initial start-up of your wood stove
Prior to initial start-up remove any adhesive labels and all
accessory components from the ash pan or the firebox, this
also applies to any transport locks that may have been used.
On models with draft baffle plates made of ceramic fibre or
vermiculite please check if these plates are located in their
anchorages (these could have slipped from their position as a
result of the transport or the installation of the chimney
stove). Otherwise these plates must be carefully hooked into
position (see Equipment Sheet).
In the case of chimney stoves with ceramic tiles the warming
compartment tiles must be placed in the warming
compartment. The ceramic tiles should be wiped clean with a
dry cloth.
For initial heating, carefully charge the wood stove with fuel
and “burn in” with a low flame. All materials must slowly
get accustomed to the heat development. By careful initial
heating you will avoid cracks in the insulating bricks, paint
damage and material distortion. Any smell developing
through re-drying of the protective varnish will disappear
after a short time.
5.4. Lighting and heating
Initially place 2 to 3 wood billets (approx. 1.5 to 2.0 kg) on
the firebox floor or grate, uncoated paper, cardboard or a
lighting cube on top, followed by brushwood, firewood or
pieces of briquettes. All existing air control dampers must be
fully opened. After lighting, close the firebox door. After
this, set the air control dampers as specified in the enclosed
Equipment Sheet.
4


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Haas-Sohn HUSUM at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Haas-Sohn HUSUM in the language / languages: English as an attachment in your email.

The manual is 0.44 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Haas-Sohn HUSUM

Haas-Sohn HUSUM User Manual - German - 6 pages

Haas-Sohn HUSUM User Manual - French - 15 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info