625721

Gys START UP 80 Manual

6
Zoom out
Zoom in
Previous page
1/24
Next page
6/24
START’UP 80
STARTER MODE USE (BOOST)
Prior precautions
• Do not disconnect the vehicle battery. The battery disconnecting can result in information loss and
in an evenutal restarting impossibility.
• The engine must be stopped.
Connection and disconnection
Do not connect to the mains supply at the beginning.
• Connect the clamps (+ red, - black) to + and - battery terminals, making sure you get
a good electric contact.
• Switch on the BOOST position.
• Plug in your charger to 230 V 50 Hz mains supply
• Let in charge for 10 minutes. This pre-charge is necessary to bring the energy for an
eventual start.
• By switching on the ignition key, you will activate the STARTER function.
This function provides only a part of the energy needed to start the engine.
• If your engine does not start, do again a 10mn pre-charge cycle before any new
attempts to start it (wait 10 minutes between each cycle).
Nb : If your engine does not start after several attempts, it is because the battery
needs to be fully charged or because there is another breakdown (either
mechanical or electrical…)
• After this step,
▪ Unplug the battery charger from the mains supply
▪ then, remove the clamps.
PROTECTIONS
Your product has been developed with a maximum of protections.
• The clamps of the battery are isolated.
• In case of polarity inversion, a buzzer sounds.
• Polarity inversion and short circuits are not dangerous. The protection is ensured by an
automatic internal circuit breaker, automatically restarting.
• Your machine is protected against over-intensity peaks which can be created by faulty batteries
or manipulations.
• Thermal protection: the transformer of the product is protected by a thermal switch (cooling:
about ¼ h).
SULFATED BATTERIES - START - POWER SUPPLY
• This START’UP 80 does not detect sulfated batteries.
Your battery is highly damaged:
- If the charger remains in charge (red or orange indicators on) more than 24h
- If in charge mode the Start’Up 80 indicates, after few seconds, that your battery is charged
but after using it, it appears that it still does not work.
• Do not use your charger like an auxiliary power supply. It is forbidden to pull up current from the
battery when the battery is connected to the charger.
… 6 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Gys START UP 80 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Gys START UP 80 in the language / languages: English, German, Dutch, French, Spanish as an attachment in your email.

The manual is 0,64 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info