625810
6
Zoom out
Zoom in
Previous page
1/15
Next page
6
OPERATION
300W MODEL:
1) Choose desired connection:
Directly onto battery: powers any device up to 300W.
Cigarette lighter: powers any device up to 150W.
2) Connection:
Connect the red clip to the red "+" terminal of the converter and the black clip to the black "-" terminal of the converter; screw
clips in place.
Caution: reversing the polarity may damage the converter.
3) Connect the converter:
Wire: Connect the black clamp to the negative "-" terminal of the battery and then connect the red clamp to the positive "+"
terminal of the battery
Caution: If the clamps are not connected securely there is a risk of low/no power, cable overheating, damage to the inverter
supply, or fire.
Cigarette lighter: Connect the cigarette lighter plug into the socket.
4) Switch the inverter ON (the green LED illuminates) and connect your equipment to the converter. (230V or USB 5V)
5) After use, unplug your equipment and then switch OFF the Convergys and disconnect it from the cigarette lighter or the
battery.
TROUBLESHOOTING
SYMPTOM
CAUSES
REMEDIES
No voltage output Bad connection Check the cigarette lighter plug and cable connections
Weak battery Check the vehicle battery
Start the engine of the vehicle if necessary
Thermal overload
Stop the device. Leave the inverter to cool ensuring
adequate ventilation.
Fuse failure (in the inverter or
vehicle)
Check and replace fuse
The device turns ON and OFF intermittently
The direct load is too high. Reduce the load
The inverter turns OFF when a connected
device is switched ON
The starting current is too high.
Check if the maximum power of the inverter is suitable for
the required power of the device
Warning Buzzer sounds
Input current below the required
level (10.2-10.8V)
The unit will start again when the battery voltage reaches
the operating level of the inverter.
Red LED illuminates
The Convergys doesn’t supply any voltage
Input current is below the
protection level (9.2-9.8V)
Input voltage exceeds the
protection level (15-16V)
The unit will start again when the battery voltage drops to
the operating level of the inverter.
Excessive load, the protection is
activated.
Reduce the charge to the power level of the converter
Warning Buzzer sounds + red LED
illuminates
The Convergys doesn’t supply any voltage
The temperature is too high. The inverter will start again as soon as it has cooled down.
NB: The USB socket should continue to operate.
6


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Gys CONVERGYS 300 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Gys CONVERGYS 300 in the language / languages: English, German, Dutch, French, Spanish as an attachment in your email.

The manual is 0,92 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info