623132

Gude GTB 20 55194 Manual

26
Zoom out
Zoom in
Previous page
1/213
Next page
2
1
6
11
10
5
4
8
7
3
8. Adjustment
1. Motor 7. Red
2. Zero voltage switch 8. Brown
3. Secondary winding 9. Yellow green
4. Blue 10. Body
5. White 11. Motor housing
6. Main winding
Quill Speed Change (Fig. 16)
1. Disconnect the drill column from the voltage source.
2. Open the pulley housing
3. Release the slide rails knob (1).
4. Tilt the motor forward to release tension on both the belts.
5. Re-set the belts in the pulleys corresponding to the required quill speed (2).
6. Stretch the belts and tilt the motor to the machine rear side.
7. Tighten the slide rails knob (1).
8. Close the pulley housing.
9. Turn the machine on to check if the belts tension is correct.
Bench Adjustment (Fig.17)
1. The bench may be lifted or lowered to a required position by releasing the column lock (1) and turning
the crank (2). Before drilling is started. the column lock has to be re-tightened.
2. If you want to turn the bench around the column. release the column lock (1) and then re-tighten it
again.
3. If you want to turn the bench only. release the bench lock (3) and turn the bench to the required
position. Re-tighten the lock again.
4. If you want to se the bench at an angle of 0
0
- 45
0
(to the right/to the left). remove the pin (4) and the
nut (5). If the pin is stuck. turn the nut (5) clockwise until the pin slips out. Release the bench lock
screw (6). incline the table at the required angle and tighten the screw (6). If you want the bench put
back in the position of 0°. insert the pin again (4) and tighten the screw (6). Transversal setting scale
spacing is on the bench attachment device (7).
26
… 26 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Gude GTB 20 55194 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Gude GTB 20 55194 in the language / languages: English, German, Dutch, French, Italian as an attachment in your email.

The manual is 3,6 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info