569642
5
Zoom out
Zoom in
Previous page
1/8
Next page
Function selection switch RADIO/ALARM:
0 = radio on
y = radio off (no alarm function)
ɷ = radio comes on at alarm time
= alarm sounds at preset time
p
connection for stereo headphones
TIME to set the clock time.
press together with SNOOZE to
show the DCF Signal strength
ALARM press briefly to display the
present alarm time
to switch off the alarm tone (or
radio) when alarm function is
activated
used with A/B to set the alarm
time
SNOOZE to interrupt radio or buzzer alarm
for approximately 6 minutes
to switch off the radio before the
preset 'sleep' time has elapsed
to indicate the seconds
press together with TIME to show
the DCF Signal strength
SLEEP to switch on the radio for
max.90 minutes
A/B for setting the clock time, alarm
time and ‘sleep’ time
VOLUME to adjust the volume
BAND
FM·MW to select between FM and MW
TUNING to tune to radio stations
Base of the set:
Battery back-up battery compartment
Connecting the unit
The unit is designed to operate from a mains
supply of 230 V, 50/60 Hz~.
When the set is connected for the first time or
after a power failure (without standby battery
fitted), the display shows 0:00 and the clock
automatically starts receiving the DCF 77 time
signal
.
Standby-battery – mains failure
If a standby battery is fitted, the clock will
continue to
operate during mains failure.
However, the display will
not be illuminated, the
radio does not work and the alarm
will not sound
unless the mains supply is restored within
2 hours
of the preset alarm time (if so, the radio will
switch on or the alarm tone will sound).
Insert a 9 V alkaline battery (IEC 6 LF 22) into
the battery compartment on the bottom of the
unit.
Insert the battery only after the unit has been
connected
to the mains in order to prevent
unnecessary drain.
We recommend that the battery is replaced
after approx. 1 year.
If the clock radio is to be disconnected for a
long
period, the standby battery should be
removed, as it would otherwise discharge too
quickly and may leak.
Note on Environmental
Protection
Do not throw exhausted batteries in
the household refuse.
Hand over the old batteries to your
dealer or
public collecting points when
buying new ones.
Technical specifications
Wavebands: FM ................87.5 – 108 MHz
MW..........526.5 – 1606.5 kHz
Power output: ............250 mW nominal power
The unit meets the CEE regulations concerning
interference radiation.
This product fulfills European directives
89/336/EEC, 73/23/EEC and 93/68/EEC.
This set complies with the safety regulations
according to VDE 0860 / BS 415 and thus
with the international safety regulations
according to IEC 65.
Subject to technical alterations and alterations
in styling. E & O.E.
Note:
The unit remains connected to the
mains even when it is switched off.
The unit is only fully isolated from the mains if
the mains plug is removed from the wall
socket.
Important note for users in the U.K.:
When fitting a mains plug, follow the
instructions on page 2.
CONTROLS POWER SUPPLY
9
Sonoclock 720 page 9
GB
5


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Grundig Sonoclock 720 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Grundig Sonoclock 720 in the language / languages: English as an attachment in your email.

The manual is 0,35 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Grundig Sonoclock 720

Grundig Sonoclock 720 User Manual - German - 8 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info