110552
7
Zoom out
Zoom in
Previous page
1/9
Next page
13
ENGLISH
Setting up the device
The speaker for the device is located at the bottom of
the device.
To optimise the sound, mount the device holder on the
bottom of the device.
UP MODE
DOWN TIMER
VOL.
MEMO
SET
ON OFF
1 2
543
6 7
8 9 10
1 Click the device
holder in place in
the recesses on the
bottom of the
device.
Mounting the device under the counter
The fixing screws can be found in the side compart-
ment of the packing.
ONOFF
1 2
543
6 7
8 9 10
UP MODE
DOWN TIMER
VOL.
1 Mark the locations
for four mounting
screws.
2 Screw the device
holder on with four
screws.
UP MODE
DOWN TIMER
VOL.
MEMO
SET
ONOFF
1 2
543
6 7
8 9 10
3 Insert the device in
the holder.
Note:
7
To remove the device, press the snap-catch at the
back and remove by pulling forward.
INSTALLATION AND SETTINGS ________________
Setting the time
1 Switch off device with »ON/OFF«.
In the display, »12:00« flashes.
2 Press »MEMO SET« and hold down.
3 Set the time with »UP« or »DOWN«.
When »UP« or »DOWN« are held down, the time
can be set more quickly.
4 Release »MEMO SET«.
Setting radio stations
There are 10 channel positions available for radio stations.
1 Switch on the device with »ON/OFF«.
2 Begin station search by pressing and holding down
»UP« or »DOWN«.
The search stops, as soon as a radio station with a
sufficiently strong signal is found.
Note:
7
You can also set the frequency step-by-step (50 kHz)
by briefly pressing »UP« or »DOWN«. Only 100
kHz steps are shown in the display.
3 Save radio station by pressing »MEMO SET«
P -« flashes in the display ), select the desired chan-
nel position within 10 seconds with »1 10« and
confirm with »MEMO SET«.
»1 … 10« press once for channel positions
1 … 5, twice for channel positions 6 … 10.
Display: the channel position is shown briefly, and
then the frequency.
4 To set further radio stations, repeat this procedure start-
ing at pt. 2.
Note:
7
If no channel position is selected within 10 seconds,
the device interrupts the setting procedure. Start
again at pt. 3.
RADIO MODE
_________________________________________________________
Radio reception
When your device is switched off, the current time is
shown in the display.
1 Switch on the device with »ON/OFF«.
The channel position appears in the display, short-
ly thereafter the station frequency.
The previous channel position is automatically se-
lected.
2 Select channel position with the »1 … 10« buttons.
»1 … 10« once Press once for channel positions
1 … 5, twice for channel positions 6 … 10.
3 Switch off device with »ON/OFF«.
In the display, the current time appears.
Adjusting the volume
1
Adjust the volume
with »+ VOL.« or »VOL. – «.
Switching the display
The display on your device supplies information about
the current time or the station frequency.
1
Call up the desired
information
with »MODE«.
7


Need help? Post your question in this forum.

Forumrules
1

Forum

grundig-sonoclock-690

Reset search

  • Klockradion blinkar hela tiden. Hur stänga av detta? Hände när strömmen bröts. Submitted on 19-1-2022 at 16:39

    Reply Report abuse
  • manual kuchynské rádio Grundig Sonoclock 690 v slovencine Submitted on 16-12-2021 at 19:45

    Reply Report abuse


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Grundig Sonoclock 690 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Grundig Sonoclock 690 in the language / languages: English as an attachment in your email.

The manual is 0,46 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Grundig Sonoclock 690

Grundig Sonoclock 690 User Manual - German - 10 pages

Grundig Sonoclock 690 User Manual - Dutch - 13 pages

Grundig Sonoclock 690 User Manual - French - 10 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info