569618
5
Zoom out
Zoom in
Previous page
1/7
Next page
Radio Reception
Switch on and off with the function selection
switch 0 y ɷ :
Setting y = radio off
Setting 0 = radio on
Select the waveband with the BAND switch:
FM = VHF
MW =
Medium Wave (Sonoclock 22/22 Q)
LW = Long Wave (Sonoclock 32)
Tune to stations with the rotary control
TUNING.
Adjust the volume with the rotary control
VOLUME.
Aerials
For receiving MW/LW stations there is a
ferrite rod aerial inside the set.
Rotating the unit slightly can improve
reception.
The wire aerial at the back of the set is
used for VHF (FM) reception.
Position the wire aerial so that optimum
reception is obtained.
Setting the clock time
Press the TIME button and hold it pressed.
Use the HOUR button to set the hours and
the MIN button to set the minutes.
A single press of the HOUR or MIN button
advances the setting by 1 hour or 1 minute
respectively. If the button is held pressed,
the setting advances continuously.
The minutes will not be carried over to the
hours if, for example, the minutes indication
changes from '59' to '00'.
Release the TIME button.
Setting the alarm time
Press the ALARM button.
The display shows the preset alarm time.
Press and hold down the ALARM
button
and set the alarm time with the
HOUR
/
MIN
buttons (in the same way as the clock time).
The light dot ALARM 6 in the bottom left of
the display shows that the alarm is ready to
operate; function selection switch
(0 y ɷ )
in position ɷ or .
8
Sonoclock 22/22Q/32 page 8
GB
POWER SUPPLY RADIOCLOCK
Connecting the unit
The unit is designed to operate from a mains supply
of 230 V, 50 Hz~.
When the set is connected for the first time or after a
power failure (without standby battery
fitted), the
display flashes to indicate that the clock
and, if
necessary, the alarm time should be set.
Standby-battery – mains failure
If a standby battery is fitted, the clock will continue to
operate during mains failure. However, the display will
not be illuminated, the radio does not work and the alarm
will not sound unless the mains supply is restored within
1 hour and 59 minutes of the preset alarm time (if so,
the radio will switch on or the alarm tone will sound).
Insert a 9 V alkaline battery (IEC 6 LF 22) into the
battery compartment on the bottom of the unit.
Insert the battery only after the unit has been connected
to the mains in order to prevent unnecessary drain.
We recommend that the battery is replaced after
approx. 1 year.
If the clock radio is to be disconnected for a long
period, the standby battery should be removed, as it
would otherwise discharge too quickly and may leak.
Note on Environmental Protection
Do not throw exhausted batteries in the
household refuse.
Hand over the old batteries to your dealer or
public collecting points when buying new ones.
Note:
The unit remains connected to the mains
even when it is switched off.
The unit is only fully isolated from the mains if the
mains plug is removed from the wall socket.
Important note for users in the U.K.:
When fitting a mains plug, follow the instructions
on page 2.
5


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Grundig SONOCLOCK 32 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Grundig SONOCLOCK 32 in the language / languages: English as an attachment in your email.

The manual is 0,25 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Grundig SONOCLOCK 32

Grundig SONOCLOCK 32 User Manual - German - 7 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info