Technical data
Amplifier part
Output power (DIN45500):
Music (4 Ω).......................................................................2 x 50 W
Nominal (4 Ω, 0.7% dist., 1 kHz) ......................................2 x 30 W
Input sensitivity / impedance:
Line IN....................................................................180 mV / 47 kΩ
Distortion: Nominal power -1dB, 8 Ω, 1 kHz................................≤ 0.01 %
Signal-to-noise ratio....................................................................≥ 94 dB
Tuner part
Sensitivity
Mono (S/N = 26 dB) ..............................................................1.1 µV
Stereo (S/N = 46 dB) ..............................................................35 µV
Frequency ranges:
FM..................................................................87.50 ... 108.00 MHz
MW ........................................................................528 ... 1605 kHz
CD part
Frequency response ± 0.1 dB............................................20 .. 20,000 Hz
Signal-to-noise ratio............................................................................96 dB
Distortion THD.......................................................................................80 dB
Dynamic range......................................................................................96 dB
General
Power supply:
Voltage.................................................................................230 V ~
Frequency..........................................................................50/60 Hz
Power consumption.............................................................. 150 W
Standby power consumption ..................................................< 6 W
Dimensions & weight
W x H x D........................................................435 x 75 (+12) x 300 mm
Weight..............................................................................approx. 5.3 kg
Extras: .........................................................................Instructions For Use
.........................................................................................Ident card
...............................................................Remote control transmitter
........................................2 x 1,5 VC micro batteries type LR06, AA
...............................................................................FM wire antenna
...............................................................AM loop antenna + screws
All rights reserved
This device is interference suppressed in accordance with applicable EC
regulations.
This device complies with safety regulation VDE 0860 and thus with
international safety regulation EN 60065.
Protection circuits
Your receiver is provided with series of electrical protection devices which
safeguard your speakers against damage. Overloads are thus almost instantly
checked. If your unit overheats, a thermal error is recognized. In this case, set is
switched off. In case this happens, you should pull the plug from the mains socket
and remove all objects that may cover the ventilation slots on the top cover of
the unit. Let the unit cool down for a few minutes before reinserting the plug.
Caring for the unit
Wipe the housing clean with a soft, dry and antistatic cloth.
Polishing and cleaning agents can damage the surface of the housing.
Trouble shooting
The following checklist will help you to correct most of the problems that can
occur with your unit.
Before you go through the following list, verify if the mains cable, antenna
cable(s) and speaker cables are securely connected.
If the following list does not help, please consult your HiFi dealer.
Problem Cause (and correction)
The receiver switches The transformer could be overheated.
off
Pull the plug from the mains socket and remove all objects
that may cover the ventilation slots on
the top cover of the
unit. Let the unit cool down for approx. 15 minutes
before before reinserting the plug.
No sound
Your unit is overheated., the volume level is automatically
reduced and the speakers are disconnected.
Pull the plug from the mains socket and remove all objects
that may cover the ventilation slots on
the top cover of the
unit. Let the unit cool down for a few minutes before
reinserting the plug.
The unit does not If the unit ‘hangs’ and you get no response whatsoever,
function this could be due to electrostatic discharge phenomena.
Pull the plug from the mains socket and re-insert.
No sound. Turn the VOLUME controller to the right.
If headphones are connected, disconnect them.
Ensure that speakers are properly connected.
Make sure that the MUTING function is not switched on (
ĭ button on the remote control).
Due to bad stereo reception the muting function is active.
Press MONO to select mono reception or adjust the
frequency.
Strong hum or hiss. Adjust the aerial.
Station signal is too weak. (Connect to an outside aerial
for improved reception).
No sound from one
speaker or incorrect Check connection of faulty speaker.
balance between
left and right speaker.
Left and right channels
Check speaker connections /cable set up.
interchanged.
No bass, or apparent
incorrect placement Check speaker connections for correct cable polarity.
of instruments.
The remote control Replace the batteries.
does not work.
Too far away from the unit, or pointed at an excessive angle
The CD does not CD player is switched to PAUSE.
function Condensation has formed on the lens of the laser due
to a dramatic change in temperature;
this will disappear
automatically after some time.
CD compartment CD not correctly inserted.
does not close.
'NO DISC' appears No CD in the compartment. CD is scratched, dirty or
in display. warped or is inserted upside down. Insert another CD.
Playback does not CD player is in PROGRAM or SHUFFLE mode.
begin with the first title.Press the STOP button and then the PLAY
button.
© 25
Important information
GB
