48
Displaying signal information
(only for digital television channels)
1Open the menu with »M«.
– The »PICTURE« menu appears.
2Select the menu »CHANNEL SETUP« with »r« or »e«.
3Select »Signal Information« with »q« or »w« and press »OK«to
confirm.
– You will see information on the channel, modulation, quality
and signal strength.
Notes:
The lower section of the menu shows the signal properties. The
further the bar for »Quality« and »Signal Strength« extends to
the right, the better the reception signal.
The signal level not only depends on your receiver system, but
also on the channel which is currently active. Remember this when
aligning your antenna using the signal level display.
4Press »M« to end the display.
Updating software
(only for digital television channels)
1Open the menu with »M«.
– The »PICTURE« menu appears.
2Select the »OPTIONS« menu with »r« or »e«.
3Select the »Software Update« menu by pressing »q« or »w«.
4Press »OK« to start the software update.
– The software is updated automatically, if possible.
5Press »M« to end the setting.
INFORMATION ------------------------------------------------------------------------------
CHANNEL SETUP
Auto Tuning
Digital Manual Tuning
Analogue Manual Tuning
Programme Table
Signal Information
CA - Module Removed
Select Back
Exit
Active Antenna Power On
s
s
s
s
Z
OPTIONS
Language Settings
Restore Factory Defaults
OSD Timeout Off
PC/HDMI Game Mode Off
Automatic Update On
Select Back
Exit
s
s
Software Update s
02Leemaxx 19_en:Layout 1 15.07.2009 10:28 Uhr Seite 48
