505530
8
Zoom out
Zoom in
Previous page
1/11
Next page
Einstellung des BIAS / Adjusting the BIAS / Régler le BIAS
Das Bias-Setting beeinflusst den Arbeitsmode des Verstärkers.
Es lässt sich von MIN > Class AB stufenlos zu MAX > Class A regeln. Im Class A Betrieb klingt der Verstärker wärmer, im
Class AB Betrieb eher knackig und direkt. Im Class A Betrieb steigt zudem auch die Stromaufnahme und die
Wärmeentwicklung. Die Ausgangsleistung ändert sich abhängig von der BIAS-Einstellung nicht
!
The BIAS-Setting controls the operation mode of the amplifier.
It is continuously adjustable from MIN > Class AB to MAX > Class A. The sound is warmer at Class A mode and more firm
and directly at Class AB mode. Please note that the current consumption and the heat build-up is higher at Class A mode.
The Powerrating will not
change dependend on BIAS-Setting.
Le CADRE(L'ARRANGEMENT) DE DÉPLACEMENT contrôle le mode d'opération de l'amplificateur.
. C'est continuellement réglable de la Classe 'AB à la Classe A. Le son est plus chaud en Classe A. En mode AB plus ferme
et directe en mode d'AB. Notez s'il vous plaît que la consommation actuelle et le développement de chaleur sont plus hauts en
mode Classe A. Le Powerrating ne changera pas dépendent sur le cadre (l'arrangement) de déplacement.
Phaseshift & Bassremote
Bitte beachten Sie, dass Phaseshift und die Bass Pegelfernbedienung nur bei eingeschaltetem Lowpass nutzbar
sind. / Please note that phase shift and bassremote are only usable at lowpass-mode switched on. /
Notez que le changement de phase et bassremote sont seulement utilisables en mode lowpass.
Wenn irgendetwas nicht funktioniert
Dieser Verstärker hat Schutzfunktionen die Schäden durch unsachgemäße Bedienung oder Bedingungen
verursacht werden. Wenn das Gerät extreme Hitzeentwicklung, einen Kurzschluss oder eine Überladung feststellt,
leuchten die Protection LEDs und das System schaltet sich ab.
Um das auftretende Problem zu prüfen sollten Sie alle Regler zurückdrehen, die Stromversorgung abklemmen
und die Installation sorgfältig auf Kurzschlüsse oder falsche Anschlüsse prüfen.
Wenn sich das Gerät aufgrund hoher Hitze abschaltet leuchten die Protection LEDs nicht. In diesem Fall lassen
Sie dem Gerät einfach Zeit um abzukühlen.
Beachten Sie die folgende Tabelle, bevor Sie das Gerät ausbauen. Testen Sie immer die Lautsprecher und
Verkabelung an erster Stelle.
Problem Kontrolle Hilfe
Kein Ton
Leuchtet die PWR LED ?
Sicherung Prüfen
Remote Kabel prüfen
+12Volt prüfen
Masse prüfen
Leuchtet die PROT LED ?
Kurzschluss am Lautsprecher
Gerät Überhitzt
Gerät defekt
Verstärker schaltet
nicht ein
Keine Stromzufuhr
Sicherung Prüfen
+12Volt prüfen
Masse prüfen
Keine Spannung am
Remote
Remote am Radio prüfen
Verstärker schaltet
bei Lautstärke ab
Lautsprecherimpedanz
prüfen
Prüfen Sie, ob der Widerstand am LS Terminal von 2 nicht
unterschritten wird
Ton Fehlt an einem
Kanal
Cinch / Lautsprecherkabel
prüfen
Kabel /Stecker beschädigt
8


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Ground zero Plutonium Reference 2XS at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Ground zero Plutonium Reference 2XS in the language / languages: English, German, French as an attachment in your email.

The manual is 1,71 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info