505524
4
Zoom out
Zoom in
Previous page
1/48
Next page
7
Einstellungen und Funktionen – GZRA 2.350G
8
Einstellungen und Funktionen
1
Stromanschluss
GND -> Masse Anschluss
REM -> Remote Antennenanschluss
BATT -> +12 Volt
2 Lautsprecheranschlüsse Zum Anschluss der Lautsprecher
3 Zustandsanzeige
GRÜN – OK
ROT – Fehler
4 Remote Control Eingang Zum Anschluss des Bass Lautstärkereglers.
5
High Pass Regler
(Subsonic)
Setzen Sie den Filter - Schalter auf “HIGH”. Justieren Sie die variable
HPF Übergangsfrequenz mit dem Regler auf die gewünschte Frequenz. Es
werden alle Frequenzen unterhalb 5 – 4000 Hz gefiltert.
6 Low Pass Regler
Für Subwoofer- und Kickwooferbetrieb -
Es werden nur noch Frequenzen unterhalb von 40 – 500 Hz (GZRA
2.350G) oder 30 – 250 Hz (GZRA 1.1200D) wiedergegeben (abhängig
von der Reglerstellung des LPF Filters). Setzen Sie den Filter - Schalter
auf “LOW”. Justieren Sie die variable LPF Frequenz mit dem Regler auf
die gewünschte Frequenz.
Bei der LPF-Einstellung ist ebenfalls der Highpass (Subsonic) aktiviert.
Dies entspricht einem Bandpass Filter von 5 – 500 Hz (GZRA 2.350G)
7 Bass Boost Regler Zum Einstellen des Bass Boost Levels im Bereich von 0 bis +12 dB.
8 Gain Regler Mit diesem Regler regulieren Sie die Eingangsempfindlichkeit.
9
Subsonic Regler
(GZRA 1.1200D)
Zum Einstellen des Subsonic Filters im Bereich von 5 bis 50Hz.
10
Phase Shift Regler
(GZRA 1.1200D)
Dieser Regler / Schalter erlaubt Ihnen, den Subwoofer phasenrichtig an
das Frontsystem anzupassen.
11 Mode Schalter
Stellen Sie die Weiche für die ausgewählte Anwendung ein.
LPF - Nur tiefe Frequenzen 40 – 500 Hz (GZRA 2.350G) werden
wiedergegeben.
FULL - Alle Frequenzen werden übertragen.
HPF - Nur mittlere und hohe Frequenzen (über 5 Hz – 4000 Hz) werden
übertragen.
Bei der LPF-Einstellung ist ebenfalls der Highpass (Subsonic) aktiviert.
Dies entspricht einem Bandpass Filter von 5 - 500 Hz (GZRA 2.350G)
12 Input
An diesen Anschlüssen schließen Sie die Cinchleitungen an.
Um Störungen zu vermeiden, verwenden Sie bitte hochwertige
Cinchkabel.
13 Output Zum Anschluss weiterer Verstärker.
14 Linkmode Zum Anschluss im Linkmodus
4


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Ground zero GZRA 1.1200D at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Ground zero GZRA 1.1200D in the language / languages: German as an attachment in your email.

The manual is 4,7 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info