759840
12
Zoom out
Zoom in
Previous page
1/14
Next page
9
RO
Domeniu de utilizare
Funcţionarea cu incinte nepresurizate (încălzitoare deschise de
preparare apă caldă) nu este posibilă!
Specificaţii tehnice
Presiunea de curgere min. 0,5 bar / recomandat 1 - 5 bar
Presiunea de lucru max. 10 bar
Presiunea de încercare 16 bar
La presiuni statice peste 5 bar se va monta un reductor de
presiune.
Se vor evita diferenţe de presiune mari între racordurile de apă
caldă şi rece!
Debit la presiune de curgere de 3 bar:
baterie pentru lavoar: cca. 6 l/min
baterie stativa pentru bideu: cca. 13 l/min
•Temperatură
Intrare apă caldămax. 80 ?C
Recomandat (cu economizor de energie) 60 ?C
Instalare
Spălaţi temeinic sistemul de conducte înainte şi după instalare
(Se va respecta norma EN 806)!
Montarea şi racordarea; a se vedea pagina pliantă II, fig. [1] până
la [8].
Se va respecta desenul cu cote de pe pagina pliantă I.
Se montează garnitura de scurgere; a se vedea pagina pliantă I.
Se etanşează cupa!
Racordarea
Se realizează legătura ventilelor laterale cu conductele de
alimentare.
Se deschide alimentarea cu apă rece şi caldă şi se verifică
etanşeitatea racordurilor.
Întreţinere
Toate piesele se verifică şi se curăţă, eventual se înlocuiesc şi se
ung cu vaselină specială pentru armături.
Se întrerupe alimentarea cu apă rece şi caldă.
Partea superioară; a se vedea fig. [9].
Se asigură ventilul lateral contra alunecării înapoi!
Piese de schimb; a se vedea pagina pliantă I (* = accesorii speciale).
CN
应用
允许与低压排量热水器一起使用!
技术数据
水流压力 最小为 0.5 /建议值为 1 - 5
工作压力 最大为 10
测试压力 16
如果静压超过 5 巴,请加装减压装置。
避免冷热水间产生大的压差。
水流压强为 3 巴时的流速:
盥洗盆: 约为 6 /
净身盆混合龙头: 约为 13 /
温度
热水入水口: 最高 80 °C
建议值: (节能)60 °C
安装
安装前后务必彻底冲洗所有管件 (考虑到 EN 806)
安装和连接,参见折页 II 中的图 [1] [8]
参考折页 I 上的尺寸图。
安装溢水组件装置,参见折页 II
密封管口套圈!
连接
为了达到这一目的,必须将侧阀连接到供水管。
打开冷热水供应管,检查连接的防水性。
维护
检查和清洁所有零件,根据需要更换零件并用专用润滑油脂润
滑零件。
停止冷热水供应。
龙头部分,参见图 [9]
将侧阀门紧贴滑动后盖固定!
备件,参见折页 I *=特殊零件)
RUS
Область применения
Эксплуатация с безнапорными накопителями (открытые
водонагреватели) не предусмотрена!
Технические данные
Давление воды миним. 0,5 бара / рекомендуется 1 - 5 бар
Рабочее давление макс. 10 бар
Испытательное давление 16 бар
При давлении в водопроводе более 5 бар рекомендуется
установить редуктор давления.
Необходимо избегать больших перепадов давлений
вподсоединениях холодной и горячей воды!
Расход воды при давлении 3 бара:
для смеситель умывальника:прибл. 6 л/мин
для смеситель для биде:прибл. 13 л/мин
Температура
на входе горячей воды макс. 80 ЃC
Рекомендовано (экономия энергии) 60 ЃC
Установка
Перед установкой и после установки тщательно промыть
систему трубопроводов (соблюдать EN 806)!
Монтаж и подсоединение, см. складной лист II, рис. [1] - [8].
Учитывать размеры чертежа на складном листе I.
Монтаж сливного гарнитура, см. складной лист I.
Уплотнить чашу!
Подключение
Подсоединить боковые вентили к распределительному
водопроводу.
Открыть подачу холодной и горячей воды, проверить
соединения на герметичность.
Техническое обслуживание
Все детали проверить, очистить, при необходимости заменить
и смазать специальной смазкой для арматуры.
Перекрыть подачу холодной и горячей воды.
Кран-букса, см. рис. [9].
Зафиксировать положение бокового вентиля!
Запчасти, см. складной лист I ( * = специальные
принадлежности).
12


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Grohe 20149 Ondus at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Grohe 20149 Ondus in the language / languages: All languages as an attachment in your email.

The manual is 0,86 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info