637248

Graupner U-16 - 2018 Manual

3
Zoom out
Zoom in
Previous page
1/6
Next page
GRAUPNER GmbH & Co. KG D-73230 KIRCHHEIM/TECK GERMANY
No liability for printing errors. We reserve the right to introduce modifications. 04/2010
3
boat is running, as leaves and other debris may get caught in the power system components. The
motors and speed controller could then be ruined by overloading.
• Dry cells and rechargeable batteries must never be short-circuited. Do not allow them to come into direct
contact with water.
• The battery charger features a time-controlled cut-off circuit. The battery should not be left on charge
unsupervised. The charge process must not be repeated in quick succession, as this would seriously
overcharge the battery, and possibly damage or even ruin it.
• Remove the batteries from the transmitter and charger if the model is not to be used for a long period.
• If the rechargeable battery in the model fails, do not dispose of it in the household rubbish. The pack
should be taken to your local battery disposal site. The model must be opened to remove the battery.
• Do not dispose of the electronic components in the model and the transmitter in the household rubbish.
Take them to your local specialist recycling centre; your local authority will tell you where it is located.
• Do not subject the model submarine, the charger or the transmitter to high levels of heat, cold or dirt.
• Secure the model, the charger and the transmitter carefully when transporting them. They may be
seriously damaged if they are free to slide about.
• Never operate the boat in moving water (e.g. a river), as its low speed and poor visibility in murky water
may result in the model drifting off downstream.
• If you have to salvage the model, take care not to risk your own life or that of others.
• Take particular care to ensure that the boat is completely watertight, as submarines will sink if too much
water enters the hull. Check the boat for damage before every run, and ensure that water cannot
penetrate. The switch flap must always be closed fully, i.e. flush with the hull, providing a watertight
seal.
• Allow the boat to dry out thoroughly after use.
Care and maintenance
• Clean the model carefully after every run, rinse the prepared model with clean water, and remove any
water which penetrates the hull. If water gets into the RC components, dry them out carefully and send
them to your nearest GRAUPNER Service Centre for checking.
• Clean the model and transmitter using suitable cleaning agents only. All you need is a lint-free cloth.
Never use chemical cleaners, solvents, methylated spirits, white spirit or similar.
• Lubricate the propeller shafts with a small drop of oil after each session, as the shaft bearings are also
the shaft seals. Use only a non-contaminating oil such as Order No. 206.
Operating instructions
• The first step is to fit the dry battery in the transmitter: undo the cross-point screw at the bottom of the
transmitter, and remove the cover plate. Insert the 9 V block battery with correct polarity, re-fit the cover
plate and tighten the retaining screw again.
Screw in
Unscrew
9 V block
battery
type 6F22
3


Need help? Post your question in this forum.

Forumrules
1

Forum

graupner-u-16---2018

Reset search

  • Graupner U-16. Charging, lighting up but not operating propeller or dive and surface functions ! Are there any servicing instructions ? Submitted on 2-4-2022 at 13:18

    Reply Report abuse


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Graupner U-16 - 2018 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Graupner U-16 - 2018 in the language / languages: English as an attachment in your email.

The manual is 0,42 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Graupner U-16 - 2018

Graupner U-16 - 2018 User Manual - German - 9 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info