590612

Gossen Metrawatt METRA HIT H-E CAR Manual

26
Zoom out
Zoom in
Previous page
1/28
Next page
26 GMC-I Messtechnik GmbH
14.2 Fuses
The fuse is located at the measuring input. When the fuse is
defective, the measurements in the m// / ranges are
faulty. The error in the V range amounts to only 10%.
If a fuse should blow, eliminate the cause of overload before
placing the instrument back into service!
Inspecting the Integrated Fuse
Ð Set the rotary switch to the measuring function.
Ð Short circuit the and jacks.
Display < 0.2 : fuse OK
Display approx. 200 k:fuse blown or poor contact at
the fuse holder
Replacing the Fuse
Ð Open the instrument as described under “Replacing the
Storage Batteries” .
Ð Remove the blown fuse with the help of an abject such
as a test probe, and replace it with a new fuse.
Table of Allowable Fuses
* These fuses are available in packages of ten from our sales offices and
distributors.
Attention!
!
Use specified fuses only!
If fuses with other blowing characteristics, other
current ratings or other breaking capacities are used,
the operator is placed in danger, and protective
diodes, resistors and other components may be
damaged.
The use of repaired fuses and short-circuiting the
fuse holder are prohibited.
14.3 Housing
No special maintenance is required for the housing. Keep
outside surfaces clean. Use a slightly dampened cloth for
cleaning. Avoid the use of cleansers, abrasives and solvents.
Disposing of Batteries or Storage Batteries
Dispose of old batteries or storage batteries properly, i.e. at a
designated collection point.
14.4 Device Return and Environmentally Compatible Disposal
The METRA HIT27 is a category 9 product (monitoring and
control instrument) in accordance with ElektroG (German
Electrical and Electronic Device Law). This device is not
subject to the RoHS directive.
We identify our electrical and electronic devices (as
of August 2005) in accordance with WEEE 2002/
96/EG and ElektroG with the symbol shown to the
right per DIN EN 50419 .
These devices may not be disposed with the trash. Please
contact our service department regarding the return of old
devices (address see chapter 17).
If you use batteries or rechargeable batteries in your instrument
or accessories which no longer function properly, they must
be duly disposed of in compliance with the applicable
national regulations.
Batteries or rechargeable batteries may contain harmful
substances or heavy metal such as lead (PB), cadmium (CD)
or mercury (Hg).
They symbol shown to the right indicates that
batteries or rechargeable batteries may not be
disposed of with the trash, but must be delivered to
collection points specially provided for this purpose.
15 Multimeter Messages
The following messages appear at the main display, or the
auxiliary displays as required. See “Symbols used in the
Digital Display” on page 2 for messages displayed at visible
segments.
Blinking Unit of Measure
All measuring functions are balanced for each METRA HIT27
at the factory in accordance with the respective technical
specification. If a unit of measure blinks, this indicates that
balancing constants which have been established and saved
to the multimeter are no longer available for the respective
function. If this is the case, measurement results may deviate
from the specification. We recommend sending the
instrument to our Repair and Replacement Parts department
for rebalancing (see chapter 17).
Type Dimensions Article Number
FF (UR) 1.6 A/1000 V AC/DC (10 kA) 6.3 mm x 32 mm Z109C *
Message Function Meaning
0. L
Measuring Indicates overflow
leads open
4-wire-m
Measuring current interrupted or fuse defective.
Pb Cd Hg
… 26


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Gossen Metrawatt METRA HIT H-E CAR at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Gossen Metrawatt METRA HIT H-E CAR in the language / languages: English as an attachment in your email.

The manual is 0,57 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Gossen Metrawatt METRA HIT H-E CAR

Gossen Metrawatt METRA HIT H-E CAR Quick start guide - English, German, French - 4 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info