346141
6
Zoom out
Zoom in
Previous page
1/7
Next page
Instructions for Use
15
The air openings in the bottom rail should be cleaned or
vacuumed periodically.
Cleaning of the condenser
Dust from the condenser should be vacuumed in the
following manner:
 push the finger through the opening in the bottom rail
and release the fastener;
 pull the rail towards you and remove it;
 remove the bottom board of the kitchen cabinet;
 pull the condenser dish out;
 use the vacuum cleaner to clean the dust from the
condenser;
 replace the condenser dish and the bottom rail in the
opposite order.
After cleaning, connect the appliance to power supply and
reload it.
Periodical cleaning of the condenser
In order to optimize the operation of the appliance and save
energy, it is recommended to periodically clean the dust from
the condenser at the back of the appliance.
Disconnect the appliance from the power mains prior to the
commencement of cleaning!
 Empty the contents of the appliance.
 Remove the supporting panel from the bottom of the kitchen
cabinet.
 Remove the screws fixing the appliance to the kitchen
worktop.
 Pull the appliance out to expose the condenser at the back
of the appliance.
 Unscrew the screws from the condenser bonnet and remove
the bonnet.
 Clean the dust and dirt from the condenser.
After cleaning return the appliance to its place, plug in the
power mains cord and fill with food.
Switch off the appliance when not in use
If you do not intend to use the appliance for a longer period, set
the thermostat knob to the STOP (0) position, disconnect the
power supply, take out the food and defrost and clean the
appliance. Leave the door slightly open.
Troubleshooting guide
During the service, you can come across some problems that
in most cases result from improper handling of the appliance
and can easy be eliminated.
The appliance fails to operate after connecting to the
mains supply
 Check the supply in the outlet socket and make sure the
appliance is switched on (thermostat knob in operating
position).
Continuous operation of the cooling system
 The door was frequently opened or it was left opened for too
long.
 The door is not properly closed (the door may sag; the
gasket may be polluted or damaged).
 Perhaps you have overloaded the appliance with fresh food.
 Insufficient cooling of compressor and condenser.
 Check the air circulation through the bottom rail openings
and clean or vacuum the dust from the condenser if
necessary. See section Cleaning and maintenance.
Ice formationon the inner rear wall
As long as water is drained through the hole in the rear and
into the receptacle at the bottom of the appliance, normal
automatic defrosting of the appliance is guaranteed.
If ice formation on the inner back wall is increased (3-5 mm),
ice should be manually defrosted.
Set the thermostat knob to STOP (0) position and leave the
door open. Never use electric devices for defrosting and do not
scrape the ice or frost layer with sharp objects.
After completed defrosting turn the knob to desired position
and close the refrigerator door.
The cause of increased ice formation may be one of the
following:
 the door does not seal well (clean the gasket if it is
contaminated or replace it if it is damaged);
 the door was frequently opened or it was left opened for
too long;
 the food stored in the refrigerator was warm;
 an item is touching the inner back wall.
Sound alarm
Excessive dust on the condenser unit is signalled by a sound
alarm heard whenever appliance door is opened until the
default is removed.
Check the air circulation through the bottom rail openings and
clean or vacuum the dust from the condenser if necessary.
See section Cleaning and maintenance.
6


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Gorenje riu 1346 la at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Gorenje riu 1346 la in the language / languages: English as an attachment in your email.

The manual is 0,51 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info