358020
9
Zoom out
Zoom in
Previous page
1/10
Next page
Instructions for Use 21
Maintenance and Cleaning
Automatic Defrosting of the
Refrigerator
There is no need to defrost the refrigerator,
because ice depositing on the inner back wall
is defrosted automatically. Ice is depositing on
the inner back wall during the compressor
operation; later on, when the compressor is not
operating ice is defrosting and water drops
collect and drain through the outlet in the inner
back wall into the drain pan situated above the
compressor, from where it evaporates.
Manual Defrosting of the Frezing
Compartment
When the frost and ice layer in the frezing
compartment is 3-5 mm thick, you should
clean the freezer.
Few hours before defrosting set the
thermostat to position 7, so that packages
are well frozen. Reset the thermostat to
STOP (0) position and disconnect the power
supply. Empty the freezer and take care that
the packages remain frozen. Leave the door
open for a while so that you can easy scrape
off the frost. Use the plastic scraper but be
careful not to damage the inner surfaces of
the freezer. Wipe up the scraped frost and
ice before it is completely defrosted.
Avoid using defrosting sprays, as they may
cause damage to the plastic parts and may
be hazardous to health.
Cleaning the Appliance
Disconnect the power supply before
cleaning the appliance. Do not use coarse or
aggressive cleaning agents as you can
damage the surface. Be careful to remove any
cleanser agent remaining after cleaning.
Clean the exterior with water and detergent.
Remove the detachable accesories in the
interior of the appliance and clean it with
water and liquid detergent. Plastic parts
cannot be washed in washing machine.
Wash the interior of the appliance with
lukewarm water, in which you added one or
two spoonfuls of vinegar.
Every now and then wipe the condenser on
the rear wall. Use soft non-metal brush or
vacuum cleaner.
Do not forget to clean also the defrost water
receptacle above the refrigerator
compressor (do not remove the receptacle).
After cleaning, connect the appliance to power
supply and reload the packages.
Switch Off the Appliance When Not In
Use
If you do not intend to use the appliance for a longer
period, set the thermostat knob to the STOP (0)
position, disconnect the power supply, take out the
foods and defrost and clean the appliance. Leave
the door slightly open.
Trouble-Shooting Guide
During the service, you can come across some
troubles that in most cases result from
improper handling of the appliance and can
easy be eliminated.
The Appliance Fails to Operate After
Connecting to the Mains Supply
Check the supply in the outlet socket and
make sure the appliance is switched on
(thermostat knob in operating position).
Continuous Operation of the Refrigerating
System
the door was frequently opened or it was left
opened for too long;
the door is not properly closed (the door may
sag, the gasket may be polluted or
damaged);
perhaps you have overloaded the appliance
with fresh foods;
9


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Gorenje rf 4248 w at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Gorenje rf 4248 w in the language / languages: English as an attachment in your email.

The manual is 0,42 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info