Manual Gorenje k 337 2 bla cela (page 7 of 8) (English)

357958

Zoom out

Zoom in

1/8

Instructions for Use

Maintenance and Cleaning

Automatic Defrosting of the Refrigerator

There is no need to defrost the refrigerator, because ice

depositing on the inner back wall is defrosted automatically.

Ice is depositing on the inner back wall during the compressor

operation; later on, when the compressor is not operating ice is

defrosting and water drops collect and drain through the outlet

in the inner back wall into the drain pan situated above the

compressor, from where it evaporates.

Freezer Defrosting

When the frost layer in the freezer is 3-5 mm thick, you should

clean the freezer.

• 24 hours before defrosting set the switch to continuous

operation (the yellow light is on) so that the food packages

are well frozen. After that empty the freezer and take care

that the packages remain frozen.

• Disconnect the appliance from the mains supply.

• Insert the enclosed pipe into the groove in the bottom of the

appliance and place a vessel underneath to collect

the defrost water. Defrosting is accelerated if the door is left

open.

• Avoid using defrosting sprays, as they may cause damage

to the plastic parts and may be hazardous to health.

Cleaning the Appliance

Disconnect the power supply before cleaning the

appliance.

Do not use coarse or aggressive cleaning agents as you can

damage the surface.

Be careful to remove any cleanser agent remaining after

cleaning.

• Clean the exterior with water and detergent.

Varnished surfaces are cleaned with soft cloth and an

alcohol based cleaning agent (for example glass cleaners).

You may also use alcohol (ethanol or isoprophylic alcohol).

The application of abrasive and specially aggressive

cleaners, such as the stainless steel cleaners, is not

appropriate for the cleaning of plastic and coated parts.

• Remove the detachable accesories in the interior of the

appliance and clean it with water and liquid detergent.

Plastic parts cannot be washed in washing machine.

• Wash the interior of the appliance with lukewarm water, in

which you added one or two spoonfuls of vinegar.

• Every now and then wipe the condenser on the rear wall.

Use soft non-metal brush or vacuum cleaner.

• Do not forget to clean also the defrost water receptacle

above the refrigerator compressor (do not remove the

receptacle).

After cleaning, connect the appliance to power supply and

reload the packages.

Switch Off the Appliance When Not In Use

If you do not intend to use the appliance for a longer period, set

the thermostat knob on the refrigerator to the STOP (0)

position, switch off the ON/OFF switch on the freezer and

disconnect the power supply, take out the foods and defrost

and clean the appliance. Leave the door slightly open.

Trouble-Shooting Guide

During the service, you can come across some troubles that in

most cases result from improper handling of the appliance and

can easy be eliminated.

Refrigerator

The Refrigerator Fails to Operate After Connecting to the

Mains Supply

• Check the supply in the outlet socket and make sure the

appliance is switched on (thermostat in operating position).

Continuous Operation of the Refrigerating System

• The door was frequently opened or it was left opened for too

long.

• The door is not properly closed (the door may sag, the

gasket may be polluted or damaged).

• Perhaps you have overloaded the appliance with fresh

foods.

• The reason may be inadequate ventilation of the compressor

and condenser (assure adequate air circulation and wipe off

the condenser).

Ice Formation on the Inner Rear Wall

As long as the defrost water runs to the channel and through

the opening to the drain pan on the compressor, automatic

defrosting of the appliance is assured.

In case the ice formation on the inner back wall is increased (3-

5 mm), ice should be manually defrosted.

Set the thermostat knob to STOP (0) position and leave the

door open. Never use electric devices for defrosting and do not

scrape the ice or frost layer with sharp objects.

After completed defrosting, turn the knob to desired position

and close the refrigerator door.

The cause of increased ice formation may be one of the

following:

− the door does not seal well (clean the gasket if it is

contaminated, or replace it if it is damaged);

− the door was frequently opened or it was left opened for

too long;

− the food stored in the refrigerator was warm;

− the food or dish is touching the inner back wall.

Water is Leaking From the Refrigerator

In case the discharge water outlet is clogged, or the defrost

water drips over the channel, water leaks from the refrigerator.

• Clean the clogged opening, for example with a plastic straw.

• Manually defrost the increased ice layer. See "Ice Formation

on the Inner Back Wall".

Bulb Replacement

Before replacing the light bulb, disconnect the appliance form

the power supply.

Press the cover at the rear side (in the arrow 1 direction) and

remove the plastic cover (in the arrow 2 direction). Replace the

bulb with a new one (E14, max. 15 W).

Don't forget: the old bulb does not belong to organic waste.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Gorenje k 337 2 bla cela in the language / languages: English as an attachment in your email.

The manual is 0,36 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Gorenje k 337 2 bla cela Manual

Product: