1. IMPORTANT SAFETY INFORMATION
• This appliance can be used by children aged from 8 years and above and persons
with reduced physical, sensory or mental capabilities or lack of experience and
knowledge if they have been given supervision or instruction concerning use of the
appliance in a safe way and understand the hazards involved. Children shall not
play with the appliance.
• Cleaning and user maintenance shall not be made by children without
supervision.
• Children of less than 3 years should be kept away unless continuously
supervised.
• Children aged from 3 years and less than 8 years shall only switch on/off the
appliance provided that it has been placed or installed in its intended normal
operating position and they have been given
supervision or instruction concerning use of the appliance in a safe way and
understand the hazards involved. Children aged from 3 years and less than 8 years
shall not plug in, regulate and clean the appliance or perform user maintenance.
• CAUTION — Some parts of this product can become very hot and cause burns.
Particular attention has to be given where children and vulnerable people are
present.
• If the supply cord is damaged, it must be replaced by the manufacturer, its service
agent or similarly qualified persons in order to avoid ahazard.
Warning: in order to avoid overheating, do not cover the heater.
• The heater must not be located immediately below a socket-outlet.
•.Do not use this heater in the immediate surroundings of a bath, a shower or a
swimming pool.
2. INSTALLATION
•Your appliance shall be used as portable appliance only (thanks to respect all the
safety warnings given below)
•Carefully put the machine on the stable floor at the correct side.
•Let a minimum distance of 1m between any side of your appliance and any
obstacle (furnitures or walls, for example) to allow a good circulation of the airflow.
•Always direct the airflow in order to optimize the heating of the room.
•Avoid the corners, small volumes, wood floors, ceiling, etc…
3. HOW TO USE
USE
- - Plug the appliance to a 220-240V~ 50Hz socket with earthing connection
- To start the heater, push the -/o switch located at the back of the appliance. You will hear a "BE
BE" sound and the power indicator lights up. The machine enters to Standby Mode
- Push the Stand by button to active the heater.
- There is a tip-over switch inside the heater, it will disconnect the heater automatically if the
heater falls down on the ground.
