334147
9
Zoom out
Zoom in
Previous page
1/11
Next page
Instructions for Use, Building- in and Connecting
11
Connecting the cooktop to the gas supply
Safety precautions
The appliance must be connected in
accordance with the standing ragulations, and it
may be used only in well ventilated rooms.
Before any attempt to connect the appliance
read carefully the instructions!
Before installation and connection check if the
local connection specifications (type and
pressure of gas) correspond to the
specifications of the appliance.
The technical specifications of the appliance
are indicated upon the rating plate.
The appliance is not suitable for connection to
the vapour release channel (chimney). The
appliance must be installed and connected in
accordance with the standing regulations.
Special attention must be paid to the particular
ventilation requirements.
Provision for ventilation
The room containing the cooker should have an
air supply in accordance with BS5440: Part 2.
The room must have an opening window or
equivalent; some rooms may also require a
permanent vent. If the room has a volume
between 5 and 10 m
3
, it will require an air vent of
50 cm
2
effective area unless it has a door which
opens directly outside. If the room has a volume
of less than 5 m
3
, it will require an air vent of 100
cm
2
effective area. If there are other fuel burning
appliances in the same room, BS 5440: Part 2
should be consulted to determine air vent
requirements.
Liquid gas connection
1 Connection extension with conical exterior
thread ISO 7-1 R ½ , wrench 22
2 Coil with interior thread ISO 7-1 Rp ½
3 Gas connection pipe
Connections
Bottom side of the cooking hob is fitted with gas
connection with exterior thread ISO 7-1 R ½.
Some appliances are provided with a coil with
interior thread ISO 7-1Rp ½.
During the installation the gas connection R ½
should be gripped tight to prevent twisting.
Use gaskets for connection sealing.
The temperature of the cooking hob bottom
exceeds the ambient temperature for 70 K. The
temperature of the ceiling and rear wall of the
oven built-in below the cooker may exceed the
ambient temperature for 70 K.
Connect the appliance to the gas supply by
means of approved hose.
If the built-in oven is located under the cooking
hob, the gas supply pipe must either be flexible
and made of stainless steel (interior and
exterior pipe), or rigid and made of copper or
steel.
The connection for the cooking hob built-in
independently may be non-metal flexible pipe,
but it must never touch the bottom of the
cooking hob.
Connection of pipe with the appliance joint must
not be submitted to torsion or any applied
pressure. This should be taken care of when
lowering the hob from upright position.; it is
important to select the most appropriate
sequence of installing connection pipe.
The hose may not touch the mobile parts of the
kitchen elements (f.e. the drawers) and should
move freely.
Connect the appliance in accordance with the
regulations of the local gas supplier.
Important! Check all the connections for
tightness after the installation!
9


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Gorenje gns 64 e inox at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Gorenje gns 64 e inox in the language / languages: English as an attachment in your email.

The manual is 0,52 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info