728735
3
Zoom out
Zoom in
Previous page
1/18
Next page
Before washing for the first time
The water softener
In order to achieve good dishwashing results, the
dishwasher needs soft water (water with low mineral
content). Hard water leaves a white coating on dishes and
the dishwasher.
Water hardness is specified using the following scales: The
German water hardness scale (°dH) and the French water
hardness scale fH). A water supply with a water hardness
in excess of 6°dH (9°fH) must be softened. This is done
automatically with the aid of the built-in water softener. In
order for the softener to function optimally, it must be
adjusted to the hardness of the water supply.
Contact the local waterworks to check the water hardness
in your area.
Adjusting the water softener
Chapter Settings on page 8 describes how to adjust the
water softener.
Fill up the salt
Before you begin using a dishwasher with a water softener,
you must fill the salt compartment with salt for the water
supply to be softened automatically. Use large grain salt or
special dishwasher salt.
Refill salt indicator
When the salt needs topping up, the above symbol lights
on the display.
When the salt runs out, unscrew the cap and fill the
container with salt. Water is only needed the first time! Wipe
clean and tighten. Run a programme to ensure that any salt
in the dishwasher is rinsed away.
After topping up, it may take a while before the symbol goes
out.
Top up with rinse aid
Drying is faster and a better result is achieved if you use
rinse aid. You will also achieve a better dishwashing result
with clear and spotless dishes.
1
Open the rinse aid compartment lid.
2 Carefully top up with rinse aid.
When the rinse-aid container is
full, the indicator will be fully dark.
3
Wipe up any splashes of rinse aid around the
compartment.
4
Close the lid firmly.
Do as follows the first time:
1
Unscrew the lid as illustrated.
2
Place the funnel supplied with the dishwasher in the salt
compartment top-up hole. First, pour in about 1 l of
water.
3
Then add salt, a maximum of 1.5 kg, until the
compartment is full.
4
Wipe up any excess salt so that the lid can be screwed
on firmly.
5
Run a programme to ensure that any salt in the
dishwasher is rinsed away.
Refill rinse aid indicator
When the rinse aid needs topping up, the above symbol
lights on the display.
After topping up, it may take a while before the symbol goes
out.
Setting the rinse aid dosage
Rinse aid dispensing can be set from 1 (low dose) to 6
(High dose). (Factory settings: 4)
Increase the rinse aid dosage:
If the dishes have water marks.
Decrease the rinse aid dosage:
If the dishes have a sticky white/blue film.
If the dishes are streaked.
Build-up of foam. If you have very soft water, the rinse
aid can be diluted 50:50 with water.
3
order to avoid rust stains a dishwashing programme
be started immediately after adding salt.
Never pour dishwasher detergent into the salt
compartment. This destroys the water softener!
3


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Gorenje GI55110 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Gorenje GI55110 in the language / languages: English as an attachment in your email.

The manual is 1,56 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info