654680
8
Zoom out
Zoom in
Previous page
1/10
Next page
8
www.mdetectors.com
GM3+PB
8. Charging the batteries.
Charging of the battery can be
The batteries have about 500-600 charge cycles - before discharge damage, however that's
values achievable in ideal laboratory terms.
The detector is complete with 2500 mAh NiMH batteries. Before you start working batteries
must be charged. Charging is made by the automatic charger offered in sets. With one
charging the detector can operate 10h. in mode, high power " (TURBO) And 50 h under
normal power. (use of headsets significantly extends the time of work).
If progress of working the lamp "Low battery" lights, this should be a signal to terminate the
work and charge the battery. Plug the charger to the socket "CHARGE" and turn the device to
a network of 220V Indicator of the presence of charge is a red led on the charger. Charging
continues 5h depending on the degree of discharge of the battery and its capacity, after its
finished the charge diodes begin to shine in green. It is not necessary to monitor the charger as
it is with automatically shut down and the battery won't be damaged, no matter how many
hours will be charged.
Back row switch off the network of 220V and remove from socket "CHARGE ".
Battery can be charged by the lighter of your car by special charger! Follow the instructions
for operating with the charger.
To ensure maximum life of your rechargeable battery:
- Don't disconnect the battery charge before it is completed
- charge the battery when it is completely down
- Use only chargers which are equipped with detector
Charger has the following additional options:
- indication of polarization of the battery or short circuit in the cable-blinking red LED.
9. Practical advice
Keep your detector of penetration of water (rain or snow) in the box with electronics and the
boz with the batteries, that can damage your detector! It can be used safely in wet grass
because of the hermetic searching drill.
Attention:
Avoid leaving the detector on wet grass or snow, because of the possibility of penetration of
moisture in the block of electronics and especially in the box of batteries!
When assembling the detector in terms of dew or snow keep the cable from wetting!
Working with the detector in urban and industrial areas may be hampered due to
electromagnetic interference and a modern iron contaminants, for normal operation of the
detector it is necessary to reduce the sound threshold (THRESHOLD) and increasing the
power of discrimination ( DISC LEVEL) which in turn leads to reduced depth of the search.
8


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for GoldenMask 3plus Powerbox at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of GoldenMask 3plus Powerbox in the language / languages: English as an attachment in your email.

The manual is 0,14 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info