636444
17
Zoom out
Zoom in
Previous page
1/19
Next page
32 33
Troubleshooting
Troubleshooting
5
There may be various reasons for abnormal operation of the receiver. Check
the receiver according to the procedures shown below. If the receiver does
not work properly after checking it, please contact your dealer or the local
Service Hotline. Do NOT try to open or disassemble the receiver. It may cause
a dangerous situation and void warranty.
Problem Possible Cause Suggested solution
No power The power cord has
not been well con-
nected
Plug the power cord into
the outlet tightly and turn
on the power; if no power
still, turn o the power
again, and turn it on in 5-10
minutes
No signal found Aerial is disconnected Check aerial lead
Aerial is damaged/
misaligned
Check aerial
Out of digital signal
area
Check with dealer
Active antenna
requires to switch
ON antenna power/
external power
Switch receiver’s Antenna
Power ON/connect external
power
No picture or
sound on TV
HDMI is not selected
on your TV or Amplier
Switch to correct TV input
HDMI is set to higher
resolution than your
TV supports
Select lower resolution on
receiver
Scrambled
channel
Message
Channel is scrambled Select alternative channel
Problem Possible Cause Suggested solution
No response to
remote control
Receiver o Plug in and turn on the
receiver
Remote not aimed
correctly
Aim remote at front panel
Front panel obstructed Check for obstructions
Remote batteries
exhausted
Replace remote batteries
Batteries connected
incorrectly
Connect batteries correctly
Beyond the eective
operation range
Operate within normal
range
Audio sounds
and subtitles
language are
not the chosen
items
The right language
channel has not been
chosen
Set the right language
channel in the menu
No sound at all The unit is in mute
status
Cancel the mute
Volume is set at too
low level
Augment the volume
Cable is connected
incorrectly
Connect the cable correctly
Serious
distortion or
cannot receive
signal normally
Too much
interferential signal
Adjust the antenna
The receiver
switches o
automatically
Auto Standby function
enabled.
Disable auto standby
17


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Globo OPTICUM HD T90 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Globo OPTICUM HD T90 in the language / languages: English as an attachment in your email.

The manual is 4,51 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info