Manual Gima A200 (page 1 of 2) (English)

783827

Zoom out

Zoom in

1/2

11109876

5432

MEMORY

Recalling the Memory

This thermometer stores 25 most recent read-

ings

Be sure the thermometer

is OFF before recalling this

memory.

Press to enter the mem-

ory mode.

Each time you press the

Memory Button, a result will

be displayed in the order of

dates (latest result shown

rst), together with “MEM”

and number (from 1 to 25).

LED in green or red will ap-

pear according to the mem-

ory reading.

When the memory is full, the

oldest result is deleted as

the new one added. When

the last record displayed in

the display, press Memory

Button again to return the

rst record.

Exit the memory.

Press ON/OFF Button to exit

the memory or keep the me-

ter in idle for 30 seconds to

switch off automatically.

Clear the memory

Delete the record by unplug-

ging the battery and power

off.

• The thermometer will automatically turn off if

left idle for 30 seconds.

As an Object Measurement Thermometer

Press “ON/OFF” Switch to turn

on the thermometer rst.

Push the Mode switch to select

Object mode.

The temperature unit ashes.

Move the probe close to the ob-

ject and take measurements.

Make sure the probe is at and

close to the object, not at an an-

gle. Perform a measurement with

a distance within 3 cm. When

ready, push measurement button

to take measurements.

Read the result.

The measurement result will be

done in 1 second. The reading is

shown together with LED lighting

and one long beep informs about

the temperature measurement,

and after a while another short

beep, conrming the saving of

the result to the memory and

readiness for the next measure-

ment.

Press the “ON/OFF” button to turn off the unit,

or leave it idle for 30 seconds, the unit will switch

off automatically.

Move the probe close to the

forehead and take measure-

ments

Make sure the probe is at and

close to the forehead, not at

an angle. Perform a forehead

measurement with a distance

within 3 cm.

Read the result.

The measurement result will be

done in 1 second. The reading

is shown together with LED

lighting and one long beep in-

forms about the temperature

measurement, and after a while

another short beep, conrming

the saving of the result to the

memory and readiness for the

next measurement.

Press the “ON/OFF” button to turn off the unit,

or leave it idle for 30 seconds the unit will switch

off automatically.

NOTE:

• As the forehead measurement temperature

is likely to be affected by sweat, oil and the

surroundings, the reading shall be taken as a

reference only.

• If the probe is placed at an angle close to the

forehead measurement, the reading will be

affected by surrounding temperature. Babies’

skin reacts very quickly to the ambient temper-

ature. Therefore, do not take their temperature

with the A200 Infrared thermometer during or

after breastfeeding, because the skin temper-

ature may then be lower than the internal body

temperature.

• If the measured temperature is < 32°C (89.6°F),

the display will show with LO symbol.

• If the reading is≥ 37.8°C (100.04°F) and <

42.9°C (109.22°F), the display will show to-

gether with red LED and six short beeps.

vary from one individual/person to next. It also

varies by location on the body and time of day.

Below shows the statistical normal ranges from

different sites. Please keep in mind that temper-

atures measured from different sites, even at the

same time, should not be directly compared. Fe-

ver indicates that the body temperature is higher

than normal. This symptom may be caused by

infection, overdressing or immunization. Some

people may not experience fever even when they

are ill. These include, but are not limited to, in-

fants younger than 3 months old, persons with

compromised immune systems, persons taking

antibiotics, steroids or antipyretics (aspirin, ibu-

profen, acetaminophen), or persons with certain

chronic illnesses. Please consult your physician

when you feel ill even if you do not have fever.

Table*1 Normal Temperature Range of various

body sites

Oral 0.6°C (1°F) or more above or be-

low 37°C (98.6°F)

Rectal/ear 0.3°C to 0.6°C (0.5°F to 1°F)

higher than oral temperature

Axillary

(armpit)

0.3°C to 0.6°C (0.5°F to 1°F) low-

er than oral temperature

PERFORM THE TEST

As a Body Measurement Thermometer

Press “ON/OFF” Button to turn

on the thermometer rst.

Push the Mode switch to select

Body mode.

The temperature unit ashes.

1. Remove the battery cover as

the arrow direction accord-

ingly.

2. Remove the old batteries

and replace with two 1.5V

AAA size alkaline batteries.

Taking care to match the

Positive ( + ) and Negative

( - ) indications

3. Close the battery cover as

the arrow direction accord-

ingly.

NOTE:

1. Although the thermometer works when “ ”,

appearing, we still recommend that you

change the batteries to obtain an accurate re-

sult.

2. Remove the batteries if stored for a long period

of time.

3. The batteries should be kept away out of chil-

dren’s reach.

If they are swallowed, promptly see a doctor

for help.

DETAILED INFORMATION

About Normal Body Temperature & Fever

The temperature in the forehead and temple area

differs from the internal temperature, which is

taken orally or rectally. Vasoconstriction, an ef-

fect which constricts the blood vessels and cools

the skin, can occur during the early stages of a

fever. In this case, the temperature measured by

the A200 Infrared thermometer may be unusu-

ally low. If the measurement therefore does not

match the patient’s own perception or is unusu-

ally low, repeat the measurement every 15 min-

utes. As a reference, you can also measure the

internal body temperature using a conventional

oral or rectal thermometer. Body temperature can

Long-press the Measure-

ment Button for 5 seconds

until the signal -- °C or °F

displayed on the LCD panel

as gure shown. Re-press

the Measurement Button to

select °C or °F unit.

Turn ON/OFF the Led Light

This meter provides Led Light to help users

placing the thermometer at the correct posi-

tion.

Be sure the thermometer is

OFF before turn ON/OFF the

Led Light.

Long-press the Measure-

ment Button for seconds

until Signal -- °C or °F dis-

played on the LCD panel.

2 Release the measurement

button, then short-press

the ON/OFF Button, the

signal -- Led or OFF will

displayed on the LCD pan-

el as gure shown.

3 Quick press the measure-

ment button, and select

Led or OFF to turn ON/OFF

the Led Light

Replacing the Battery

The meter will display “ ” to alert you when

the meter power is getting low, please follow

the steps below to replace new batteries im-

mediately.

Display Screen

1. Body mode indication

2. Object mode indication

3. Memory indication

4. Temperature reading

5. Temperature unit

6. Battery indication

Display Mode

Two modes can be selected.

1.Body Mode

This mode is used to

measure the forehead

temperature.

2.Object Mode

This mode is used to

measure the object tem-

perature.

Select the Temperature Unit

This meter provides two measurement units

used for indicating the body/object tempera-

ture, °C or °F, for your preferred selection.

Be sure the thermometer

is OFF before selecting the

temperature unit.

How does it work

The thermometer measures the infrared heat

generated by the surface of the skin over the ves-

sel and its surrounding tissue. The thermometer

then converts it into a temperature value.

NOTE:

The thermometer does not emit any infrared en-

ergy.

Highlighted Features

• Measurement that does not require probe cov-

er, thereby saving cost of replacement.

• Automatically power off if left idle for 30 sec-

onds.

• Memory function allows you to recall previous

results up to 25 previous results.

• Easy to read LCD with green backlight in a dark

environment.

• Color visible of fever (red) and measurement in

progress (green).

Meter Overview

1. nfrared Sensor

2. Led Light

3. Display Screen

4. Measurement /

Memory Button

5. ON/OFF Button

6. Mode Switch

7. Battery Cover

instructions to assist to SERVICE PERSONNEL

in parts repair.

• Do not clean or maintenance the device is in

use.

• Avoid direct sunlight.

• Avoid dropping the thermometer, if it happens

and you think the thermometer may be dam-

aged, please contact customer services imme-

diately.

• Do not touch the lens.

• Do not disassemble the thermometer.

• Basic safety precautions should always be

observed, especially when the thermometer is

used on or near children and disabled persons.

• This thermometer is not intended to substitute

for a consultation with your physician.

• This thermometer and the subject must remain

in a stable environment for at least 30 minutes

before measuring the temperature.

• When the measured temperature falls with-

in the fever temperature range of ≥37.8°C

(100.04°F) and <42.9°C (109.22°F), as indicat-

ed by the red LED on display, please consult

with your physician immediately.

Restrictions of Use

This thermometer is clinically proven to produce

accurate temperature measurements. However,

please be advised that the accuracy can not

be ensured when the thermometer is not clean.

Check that the probe is clean before taking a

measurement.

Intended Use

A200 Infrared Thermometer is intended for the

intermittent measurement and monitoring of hu-

man body temperature from forehead measure-

ment at home, clinics and hospital.

A control measurement using a conventional

thermometer is recommended in the following

cases:

1. If the reading is surprisingly low.

2. For new-born infants, up to 100 days old.

3. For children under three years of age who have

a weakened immune system or who react unu-

sually in the presence or absence of fever.

MEMORY ......................................................... 11

Recalling the Memory ...................................... 11

Clear the memory ............................................ 11

MAINTENANCE ............................................... 12

Care & Cleaning ............................................... 12

FAULT INDICATION ......................................... 12

SYMBOL INFORMATION ................................ 13

SPECIFICATIONS ............................................ 14

DISPOSAL OF DEVICE .................................... 15

REFERENCE OF STANDARDS ........................ 15

Device Standards: ........................................... 15

Classication: .................................................. 15

Electromagnetic Compatibility: ....................... 15

WARRANTY ..................................................... 17

MANUFACTURER’S DECLARATION

OF THE EMC ................................................... 21

BEFORE YOU BEGIN

Cautions and Warnings

• As with any thermometer, proper technique is

crucial to obtaining accurate temperature read-

ings. Please read this manual thoroughly and

carefully before using.

• Always operate the thermometer in an operat-

ing temperature range 10°C to 40°C (50°F to

104°F), and relative humidity15 to 95%.

• Always store the thermometer in a cool and dry

place -25°C to 55°C (-13°F to 131°F) and rela-

tive humidity 15% to 95%.

• The device requires no calibration. The product

has been calibrated before the factory inspec-

tion.

• The device contains no user serviceable parts.

• The user must check that the equipment func-

tions safely and see that it is in proper working

condition before being use

• The manufacturer does not require such pre-

ventive inspections by other persons.

• No modication of this equipment is allowed.

• The device is not suitable for use in the pres-

ence of ammable anesthetic mixtures with air

or with oxygen or nitrous oxide.

• Manufacturer will provide circuit diagrams,

component part lists, descriptions, calibration

System Owner

Thank you for purchasing the A200 Infrared Ther-

mometer. Please read this instruction manual

ﬁrst, so you can use this thermometer safely and

correctly. Please keep this instruction manual for

future reference. This innovative medical device

uses advanced infrared (IR) technology to meas-

ure temperature instantly and accurately on the

forehead or object.

IMPORTANT SAFETY INSTRUCTIONS

READ BEFORE USE

The following basic safety precautions should

always be taken.

1. Close supervision is necessary when the ther-

mometer is used by, on, or near children, hand-

icapped persons or invalids.

2. Use the thermometer only for the intended use

described in this manual.

3. Do not use the thermometer if it is not working

properly, or if it has suffered any damage.

KEEP THESE INSTRUCTIONS AT A SAFE

PLACE

CONTENTS

BEFORE YOU BEGIN ........................................ 2

Cautions and Warnings ..................................... 2

Restrictions of Use ............................................ 3

Intended Use ..................................................... 3

How does it work .............................................. 4

Highlighted Features ......................................... 4

Meter Overview ................................................. 4

Display Screen................................................... 5

Display Mode..................................................... 5

Select the Temperature Unit .............................. 5

Turn ON/OFF the Led Light ............................... 6

Replacing the Battery ........................................ 6

DETAILED INFORMATION ................................. 7

About Normal Body Temperature & Fever......... 7

PERFORM THE TEST ........................................ 8

As a Body Measurement Thermometer ............ 8

As an Object Measurement Thermometer ...... 10

A200 INFRARED

NON CONTACT

THERMOMETER

Please note:

This medical instrument must be used

according To instructions to ensure

accurate readings.

Gima S.p.A.

Via Marconi, 1 - 20060 Gessate (MI) Italy

gima@gimaitaly.com - export@gimaitaly.com

www.gimaitaly.com

PROFESSIONAL MEDICAL PRODUCTS

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Gima A200 in the language / languages: English as an attachment in your email.

The manual is 0.42 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Gima A200 Manual

Product: