558403
13
Zoom out
Zoom in
Previous page
1/15
Next page
13
NOTE”:
it is best to thread the wire between the door and the chassis so that the gaskets will protect it
CONNECTIONS
Power supply: GEONAV can be powered with the incorporated battery back or by plugging the power cord into the
cigarette lighter. Insert the cable, matching the arrows of the connector to the arrows on the entrance (see figure),
pushing gently until it snaps in.
To remove the cable, pull the ring outward without turning.
Always insert the special protective rubber cap onto the connector when the cord is disconnected.
Power supply from fixed network: The adaptor has a small LED that lights up when the power is supplied correctly. If
the light turns of after inserting the adaptor into the cigarette lighter:
• check that the power is supplied to the socket;
• check that the adapter fuse is working properly.
Open the adaptor and check the fuse. If the fuse is broken, replace it with a fuse with the same characteristics.
NEVER USE A BYPASS CIRCUIT.
The fuse ensures that the protection circuit contained in the GEONAV triggers in the case of short circuit, inversion of
polarity and voltage surges. If you prefer to avoid the use of the adaptor, the internal connections must be as follows: red
(or white) + (+ 12V), black - (earth)
Battery pack: The instrument comes with a battery pack for use in the portable mode. Use 4 AA alkaline or
rechargeable batteries (best if high capacity, 2000mAh or higher).
Replace the batteries with the machine off and the instrument dry. To access the battery housing, loosen the lock screws
using a coin or the rounded part of a key.
Remove the battery pack and loosen the studs. Remove them and insert the batteries while complying with the polarity
indicated.
Make sure the "Battery type" selector is located in the cartridge housing in the correct position for the
type of batteries being used (“Rechargeable” position for rechargeable batteries, “Alkaline” position for alkaline batteries).
If necessary, change the selection by moving the lever with the tip of a pointed object.
: All the instruments are supplied by the factory with the selector set for use of alkaline batteries. If
alkaline batteries are used, the selector must be positioned on “Alkaline”. It is essential to NEVER use alkaline batteries
if the selector is in the “Rechargeable” position which can seriously damage the instrument. Incorrect positioning of the
selector can cause the batteries to break and corrosive liquid to seep out.
13


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Geonav 4C at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Geonav 4C in the language / languages: English as an attachment in your email.

The manual is 1,46 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Geonav 4C

Geonav 4C User Manual - Dutch - 83 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info