PAG. 8
PAG. 9
ANTI-HIJACKING FUNCTION
We suggest to keep the TAG separately from the remote control (usually
kept with the vehicle key) for safety reasons and to enable the anti-
hijacking function to control the vehicle speed.
NOTE: activation of the anti-hijacking function does not mean the
vehicle immobilization but the starting of the reception procedure and
authentication of the radio code.
The system ref.7629 is equipped with the anti-aggression function.
This function is able to immobilize the engine in case of an aggression against
the vehicle's owner.
The anti-aggression function is based on the use of an automatic transmitter,
(called TAG, ref. 7708), the which code is memorized in the system.
ATTENTION: for a correct work of the anti hijacking funtion, it is
necessary the connection of the BROWN/GREEN wire to
the doors switch.
DEVICE POWER ON
The power-on of the transmitter is obtained by pressing the button located on
the TAG for al least 3 seconds: the Led of the TAG will be lighted until the button
will be released.
The status ON of the TAG is signalled by a short flash, (every 3”), of the TAG’s
Led.
The coded data from the TAG are transmitted to the system periodically and,
when the system receives the signal, the status led blinking.
DEVICE POWER OFF
The power-off of the transmitter is obtained by pressing the button located on
the TAG until the Led will be lighted.
The status OFF of the TAG is signalled by 3 short flashes of the Tag's Led
VEHICLE'S STARTING
Start the vehicle by turning in “ON” position the ignition key.
The system ref.7629 will wait a transmission from the TAG for a time of 2
minutes: if one transmission will be detected, the anti-aggression function will
be enabled.
If no transmission are received, the anti-aggression function is not enabled.
This automatic procedure allows to use the vehicle in security mode if the use
forget the TAG or if the TAG is not properly working, (e.g. fault or battery
discharged).
When the vehicle is running or in any case when positive under key is present,
not receiving the signal sent out from the TAG, the module will be activated with
the anti-robber function, immobilizing the vehicle as described in next
chapters.
In order to avoid involuntary activation of the anti-robber system and
consequently the vehicle´s immobilizing, you must pay attention to its state,
when you are close to the vehicle.
VEHICLE RUNNING; USER AGGRESSION AND CAR HIJACKING
ATTENTION: For the correct work of the anti-aggression function, the
user must hold the transmitter when the vehicle will be
stolen.
If the driver's door will be opened during the vehicle running and the vehicle will
be stolen, the radio contact between the TAG transmitter and the alarm will be
lost.
Sixteen seconds after the opening of the driver's door the system's status Led
will be lighted in order to signal the activation of the anti-aggression count-
down.
In this situation, for safety reasons, the car’s running is not interrupted.
After one minute from the opening of the driver's door the system will enable
the vehicle's immobilization, as described in next paragraphs (in addition to the
sirene sound for 2 minutes)
INSTALLATION WITH CONNECTION OF THE ODOMETER SIGNAL
The vehicle will be immobilized when the vehicle is running and its speed will
be near to 0 km/h.
The immobilization of the vehicle will be signalled by the flashing of the
direction lights, (for about 3 hours).
NOTE: the odometer sensor, ref.7667, must be connected to the alarm
system, ref.7563.
INSTALLATION WITHOUT CONNECTION OF THE ODOMETER SIGNAL
The vehicle will be immobilized when the engine will be turned OFF for the first
time. It will not be possible to start again the vehicle's engine.
The immobilization of the vehicle will be signalled by the flashing of the
direction lights, (for about 3 hours).
SYSTEM DISARMING WITH TAG CARD
In order to disarm the engine's immobilization (and to start again the vehicle),
it's mandatory to approach to the vehicle with the TAG transmitter, (switched
“ON”).
When the module recived again the TAG codified signal, it deactive the anti-
hijacking function and stop turn signals flashes.
SYSTEM DISARMING WITHOUT TAG CARD
This procedure can be used if there are some problems with the TAG card or
with the anti-hijacking function (ex. Damage or battery discharge of the TAG
card with enabled anti-hijacking function and vehicle running).
It's possible to disarm the engine's immobilization with the following
procedure:
! Push the button located on the status Led or insert the electronic key into
the receptacle, after at least 2 minutes from the start of the engine's
immobilization.
! Push, within 2 seconds, the button N°2 of the remote control and then
press, within 2 seconds, the button N°1 of the remote control.
.
