544635
4
Zoom out
Zoom in
Previous page
1/6
Next page
Der gewünschte Handsender wurde nun gelöscht!
geba GmbH ist von der Gewährleistung und Produkthaftung befreit, wenn ohne unsere vorherige
Zustimmung eigene bauliche Veränderungen vorgenommen werden oder unsachgemäße
Installationen, gegen unsere vorgegebenen Montagerichtlinien, ausgeführt bzw. veranlasst werden.
Der Weiterverarbeiter hat darauf zu achten, dass die EMV-Vorschriften eingehalten werden.
Montageanleitung
Montage der Auswerteeinheit (Innenbereich):
1. Schraubendreher in Schlitz auf Gehäusedeckel einstecken, nach oben hebeln und den
Deckel öffnen.
2. Entfernen Sie die Steuerplatine (nur gesteckt).
3. Montieren Sie die mitgelieferten Kabel - Verschraubungen in das Gehäuse und stecken
Sie die Platine wieder auf. Achten Sie hierbei auf richtiges Einschnappen der Platine.
4. Bohren Sie die Befestigungslöcher und schrauben Sie den Befestigungsbügel an der
Wand fest.
5. Die Leitung für die Tastatur führen Sie nun durch den linken Kabel-Eingang
(Dichtnippel) und die Netzleitung durch den rechten Kabel-Eingang. Achten Sie auf dichten Sitz
von Dichtnippel und Kabelverschraubungen, sonst ist der Geräteschutz nicht gewährleistet.
6. Schließen Sie die Leitungen gemäß Anschlussplan an die entsprechenden Klemmen an.
Handsender
Löschen von Handsendern
Montageanleitung
Löschen spezifischer Handsender:
Die eingelernten Handsender des ausgewählten Relais wurden nun
alle gelöscht!
DIP 4 auf ON
stellen
DIP des
verwendeten
Relais (1oder 2)
auf ON stellen
zu löschende Taste des
Handsenders > 5 sek.
betätigen
Alle DIP auf OFF
stellen
DIP des zu
löschenden Relais
(1 oder 2) auf ON
stellen
Reset-Taste auf
der Logikplatine
> 5 sek. drücken
Alle DIP auf OFF
stellen
DIP 4 auf ON
stellen
LED blinkt
(2x lang)
Löschen aller Handsender eines einzelnen Relais:
4


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Geba Tronic Cody Light HF 1-1 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Geba Tronic Cody Light HF 1-1 in the language / languages: German as an attachment in your email.

The manual is 1,05 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Geba Tronic Cody Light HF 1-1

Geba Tronic Cody Light HF 1-1 User Manual - Dutch - 6 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info