714692
36
Zoom out
Zoom in
Previous page
1/40
Next page
36
• Neverimmersepowerbaseorcordinwater.Cleanthepowerbasewithawarmdamp
clothorspongeanddrywithasofttowel.Donotletanyliquidrunintothepowerbase.
Cleaning of the Frothing Disc
Take the frothing disc off the shaft and carefully wash with warm soapy water using a spon-
ge or scrubber pad. Rinse with water and dry with a soft towel.
Note: In case of grease residues on the frothing disc, the frothing process will be disturbed,
because the grease of the fresh milk can not get filtered out. The result will be less or no froth.
Cleaning of the Jug
• Neverimmersethejuginwater.
• Thejugshouldneverbeplacedinanautomaticdishwasher!Thiswouldcausedamageto
the electronic components in the bottom of the jug.
• Immediatelyaftereachuseplaceasmallamountofwarmwaterinthejugtosoak.The
water helps prevent the build up of ingredients on the non-stick coated surface and makes
cleaning easier.
• Carefullywashthejugandlidwithwarmsoapywaterusingaspongeorcloththatis
suitable for cleaning non-stick coating. Rinse with cold water and dry with a soft towel.
• Becarefulnottodamagethenon-stickcoatingofthejug.
• ATTENTION: Never use abrasive cleaners, any chemicals, disinfectants, cleaning pads
or any sharp utensils (i.e. metal scouring pads) for cleaning.
• Cleantheouterhousingofthejugwithawarmdampclothorspongeanddrywithasoft
towel.Donotletanyliquidrunintothehousingofthejug.
• IMPORTANT: Ensure to clean all residues from the bottom of the jug to avoid scorch of
ingredients.
• Alwaysrinsethejugwithclearcoldwaterbeforefrothing.
• Tocleanstubbornresiduesfillsomedishwasherdetergentintothejugandaddalittle
bit of hot water. Soak the residues for approximately 15 minutes before emptying the jug.
Thoroughly rinse the jug with cold clear water afterwards.
• Tocleanallresiduesofthedetergentassembletheappliance,fillthejugtothemaxlevel
indicator for frothing milk (120 ml) with clear cold water and turn the appliance on. Pour out
the water. The appliance is ready for use.
• Occasionally,itisrecommendedtooperatetheappliancewithasmallamountofnonsud-
sing detergent. Fill jug to the max level indicator for milk froth with warm soapy water and
turn the appliance on. Rinse thoroughly with cold clear water afterwards.
• Careshouldbetakenwhencleaningsmallerparts,suchastheattachments,toavoid
accidentally dropping in the garbage disposal or discarding in the trash.
• Priortouseandbetweenconsecutivecycles,theapplianceshouldberinsedwithcold
water to insure proper operation.
WARNING : To reduce the risk of fire or electrical shock, do not remove the bottom cover
from the power base or disassemble the containers heating unit. Repair should be done by
authorised service personnel only.
36


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Gastroback 42325 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Gastroback 42325 in the language / languages: English, German as an attachment in your email.

The manual is 0,93 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info