724639
12
Zoom out
Zoom in
Previous page
1/16
Next page
26cc 2-Stroke Hedge Trimmer
AFTER SALES SUPPORT
e-mail: help@powertoolsupport.com
1800 909 909
MODEL: №. MQE-3SPK-560 • 43671 • 09/2018
(toll free)
AFTER SALES SUPPORT
(toll free)
26cc 2-Stroke Hedge Trimmer
e-mail: help@powertoolsupport.com1800 909 909
MODEL: №. MQE-3SPK-560 • 43671 • 09/2018
20 21
Maintenance Maintenance
Blade Lubrication
WARNING: Before lubricating, be sure your
hedge trimmer is switched o and blades
(1) have come to a complete stop.
For easier operation and longer blade life,
lubricate the blade before and after each use.
Apply light machine oil along the edge of the
blades/s (1) bar (Fig J).
Greasing
The engine requires re-greasing after approximately
every 25 hours of operation.
Apply lithium grease into the gearbox through the
grease tting after 25 hours running (Fig K).
Air Filter
CAUTION: NEVER operate this unit without the air
lter as dust and dirt will be sucked into the engine
and damage it. Accumulated dust in the air lter will reduce engine eciency,
increase fuel consumption and allow abrasive particles to pass into the engine.
Remove the air lter as often as necessary and maintain a clean condition of the
lter and cylinder ns.
To Clean the Air Filter:
1. Turn the knob on the air lter cover (9) in an anti clockwise direction to
loosen and remove (Fig L).
2. Remove the air lter and wash the lter in soap and water (Fig M).
DO NOT USE PETROL!
3. Air dry the lter.
4. Reinstall the air lter and
close the air lter cover (9).
NOTE. Replace lter if
frayed, torn, damaged
or unable to be cleaned.
Carburettor Adjustment
The carburettor is pre-set at the factory for optimum performance.
If further adjustments are necessary take your unit to a qualied service dealer.
Spark Plug
Starting failure is often caused by a fouled spark plug.
Periodically clean the spark plug and replace with a
new one if necessary.
NOTE. Spark plug gap = .025 in. (.635mm) (Fig 8).
1. Remove the spark plug cover (5).
2. Use the supplied spark plug spanner / combination screwdriver (23)
to remove the spark plug (6), by turning it counter-clockwise.
(Torque to 130 inch pounds (15 Nm)
3. Clean and adjust the spark plug gap to 0.6 - 0.7mm. Replace any
damaged or visibly worn plug with a new spark plug - model Torch L9T or
NGK BPMR7A.
4. Install the spark plug (6) nger tight, then tighten with the supplied tube
spanner / screwdriver. Do not over-tighten.
NOTE. If your spark plug becomes worn, replacements are available for
purchase.
Please refer to page 23 for further detail.
J.
K.
L. M.
12


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Gardenline MQE-3SPK at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Gardenline MQE-3SPK in the language / languages: English as an attachment in your email.

The manual is 0,78 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info