718557
25
Zoom out
Zoom in
Previous page
1/84
Next page
19
ENGLISH
>
Try 2 or 3 times.
If the machine does not start, contact the Gaggia hotline and mention the error
code shown on the display. Contacts are included in the warranty booklet supplied
separately or can be found at www.gaggia.com.
9.4 Troubleshooting table
Behaviour Cause Action
The machine does not turn
on.
The machine is disconnected or the
main switch is in the OFF position.
Plug in the machine and place the main switch in the
ON position.
The machine is in simulated
working mode.
The STAND-BY button has been
pressed for more than 8 seconds.
Turn the machine OFF and ON using the main switch.
Thedriptrayllsupquickly. To guarantee a perfect coffee at
every brewing, the machine rinses
andwarmsitselfbyushingwaterin
the drip tray.
Empty the drip tray. To avoid that rinsing water ends
in the drip tray, place a cup below the dispensing
spouts.
The ‘Coffee grounds drawer
full’ signal is still on, even if
it’s emptied or with only
few coffee grounds in it.
The coffee grounds drawer has been
emptied while the machine was off.
After emptying drip tray and coffee grounds drawer,
wait for the ‘Close service door’ signal to be displayed.
Place the components back.
It is impossible to remove
the brew group.
The brew group is incorrectly
positioned.
Close the service door. Turn the machine off and back
on again. Wait for the ‘Ready for brewing’ signal and
then remove the brew group.
The coffee grounds drawer is in place. Remove the coffee grounds drawer before removing
the brew group.
It is impossible to insert the
brew group.
The brew group is not in the idle
position.
Make sure that the brew group is in the idle position
as described in the “7.2.1 Weekly brew group cleaning
cycle” chapter, “Reassembly phase”.
The gearbox is incorrectly positioned. Place the drip tray and coffee grounds drawer in
their proper seats. Close the service door. Turn the
machine on without the brew group. The gearbox
goes back to the correct position. Turn the machine
off and put the brew group in place following the
instructions in the “7.2.1 Weekly brew group cleaning
cycle” chapter, “Reassembly phase”.
Coffee has too little cream
or is watery.
Grinders are set to a coarse position. Adjustthegrindingnenessasdescribedinthe“5.3.3
Ceramic coffee grinder adjustment” chapter.
The blend is not right, coffee is not
freshly roasted or is ground too
coarse.
Changecoffeeblendoradjustthegrindingneness
as described in the “5.3.3 Ceramic coffee grinder
adjustment” chapter.
The machine must perform the self-
adjustment.
Brew a few cups of coffee.
Coffee is leaking from the
coffee dispensing spout.
The coffee dispensing spout is
clogged.
Clean the coffee dispensing spout and its holes using
a toothpick.
Coffee is not hot enough. Cups are cold. Warm the cups with hot water.
The temperature is incorrectly
regulated.
Adjust the temperature as described in the “5.3.4
Brewing temperature adjustment” chapter.
The machine circuit is clogged by
limescale.
Descale the machine as described in the “7.5
Descaling cycle” chapter.
The machine grinds the
coffee beans, but coffee
does not come out.
Water empty. Fill the water tank and prime the circuit again as
described in the “5.2.1 Water circuit priming” chapter.
The brew group is dirty. Clean the brew group as described in the “7.2.1
Weekly brew group cleaning cycle” chapter.
The circuit is not primed. Prime the circuit as described in the “5.2.1 Water
circuit priming” chapter.
The coffee dispensing spout is dirty. Clean the coffee dispensing spout and its holes using
a toothpick.
The machine must perform the self-
adjustment.
Brew a few cups of coffee.
25


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Gaggia Anima de Luxe at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Gaggia Anima de Luxe in the language / languages: English, German, Italian as an attachment in your email.

The manual is 32,78 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Gaggia Anima de Luxe

Gaggia Anima de Luxe User Manual - French, Portuguese, Spanish - 84 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info