781739
40
Zoom out
Zoom in
Previous page
1/102
Next page
Original Bedienungsanleitung FUXTEC FX-MH126_de_en_fr_ita_rev10
40
left open (F3)
4. too much choke can lead to starting problems due to overly excessive fuel flow. If
the Engine cannot be started after several attempts, open the choke and pull the
starter cable repeatedly or remove the spark plug and dry it.
STOPPING THE ENGINE (F1)
1. release the throttle valve lever and let the Engine run for half a minute
2. move the ignition switch to the "0"(STOP) position
If the Engine does not stop after switching off, close the choke so that the Engine stops
after a while.
IMPORTANT
During the first 20 hours of operation, the hedge trimmer should not be used at full
power for long periods.
ADJUSTING THE IDLE SPEED
- Before adjusting the carburettor, clean the air filter and let the Engine run warm.
- The idle limiting screw is adjusted so that there is a sufficient safety margin between
the idle speed and clutch engagement.
(1) Air filter (F5)
(2) Idle speed limiter screw (F6)
When the Engine is idling (2,700 ~ 3400 rpm), the blade should not move. You can
adjust the carburettor yourself (please contact our customer service). However, we
recommend having this done by an authorized mechanic.
WARNING!
40


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Fuxtec FX-MH126 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Fuxtec FX-MH126 in the language / languages: English, German, French, Italian as an attachment in your email.

The manual is 2.21 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info