747962
3
Zoom out
Zoom in
Previous page
1/6
Next page
Anschlussschema (Beispiel )
LED Indikation
SYSTEM Mode LED Status Link LED
FASSTest Grün permanent
Kein Signal
Signal empfangen
Warten auf Link
Rot permanent
Grün permanent
Start-> nach 2 sek.-> rot
blinkend
FASST off
Kein Signal
Signal empfangen
Signal empfangen, ID
ungültig
Warten auf Link
Rot permanent
Grün permanent
Grün blinkend
Rot blinkend
FASSTest
FASST
-- Nicht behebbarer Fehler
(EEPROM, etc)
rot / grün abwechselnd
blinkend
FASSTest < > FASST Mode wechseln
1. Empfänger einschalten ( Fernsteuerung aus )
2. Link/ Mode Button für min. 5 Sek gedrückt halten
3. Sobald die LED beginnt rot/grün zu blinken, Button loslassen
4. Die LED sollte nun rot blinken ( siehe Tabelle unten )
5. Den gewünschten Mode durch Drücken des Mode/ Link Buttons auswählen (
default: FASSTest)
6. Mode / Link Button für 2 Sek. gedrückt halten
7. Die LED hört auf zu blinken
8. Empfänger aus- und wieder einschalten
Rote LED blinkt System
1 mal FASSTest
2 mal FASST Multi-ch Normal Mode
3


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Futaba R7018SB at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Futaba R7018SB in the language / languages: German as an attachment in your email.

The manual is 0,13 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Futaba R7018SB

Futaba R7018SB User Manual - English - 5 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info