747945
1
Zoom out
Zoom in
IMPORTANT
:
Since the 2.4GHz have different characteristics than that of the conventional 27MHz and 72MHz
frequencies, please read this addendum carefully to enjoy safe flight with the 2.4GHz system.
[Receiver's Antenna Installation]
The R617FS has two antennas. These antennas
have a diversity function to decrease the chance of a
receiving error.
Since the wavelength of the 2.4GHz is much shorter
than that of the conventional frequencies 27MHz
and 72MHz, it is very susceptible to loss of signal
which results in a receiving error. In order to avoid this
phenomenon, the R617FS adopted a diversity antenna
system.
To obtain the best results of the diversity function,
please refer to the following instructions;
1. The two antennas must be kept as straight as
possible. Otherwise it will reduce the effective range.
2. The two antennas should be placed at 90 degrees to
each other.
This is not a critical figure, but the most important thing
is to keep the antennas away from each other as much
as possible.
Larger models can have large metal objects that can
attenuate the RF signal.In this case the antennas
should be placed at both sides of the model. Then
the best RF signal condition is obtained at any flying
attitude.
3. The antennas must be kept away from conductive
materials, such as metal and carbon by at least a half
inch. The coaxial part of the antennas does not need
to follow these guidelines, but do not bend it in a small
radius.
If the fuselage is made of conductive materials such as
metal and carbon, the antennas part MUST be placed
at outside of the fuselage. In addition, do not attach
the antenna part on the fuselage. For example, there
are many types of gliders which use carbon fuselage.
When install the receiver into that kind of fuselage, this
guideline must be kept.
4. Keep the antennas away from the motor, ESC, and
other noise sources as much as possible.
5. Be very careful when handling the receiver
antennas. Repeated motion in or out of the case holes
or excessive pulling force could break or compromise
the internal antenna connections.
1M23N21301 ©FUTABA CORPORATION 2008, 03 (1)
R617FS
7 channel receiver of FASST system
Futaba R617FS 7 channel receiver of FASST system is packed in this set.
*The two antennas should be placed at 90 degrees to each other.
*The main purpose of the photo demonstrates how the antenna
should be placed. For actual i nstallation the receiver must be
wrapped with a sponge or placed with floating material to protect
it from vibration.
Antenna Antenna
Antenna
*Must be kept as straight as possible.
Coaxial cable
R617FS Receiver
R617FS Specifications
Dual antenna diversity
Power requirement: 4.8V or 6.0V battery or regulated
output from ESC, etc.
(*1)
F/S and Battery F/S function for throttle channel (channel three)
Size: 1.64 x 1.08 x 0.36 (41.6 x 27.5 x 9.2 mm)
Weight: 0.34 oz (9.8 g)
(*1)
Be sure that when using ESC's regulated output the
capacity of the ESC must meet your usage condition.
(Specifications are subject to change without prior notice.)
LED status of the reciver's condition
Green Red Status
Off Solid No signal reception
Solid Off Receiving signals
Blink Off Receiving signals but ID is unmatched
Alternate blink Unrecoverable failure (EEPROM, etc.)
R617FS “F/S set” and “Easy-link” Operation
0 to 1 sec. 1 to 2 sec.
More than 2 sec.
0 sec. 1 sec. 2 sec.
Press and Hold time
No function
With TM-7,
TM-8
(7ch mode)
To set the F/S
position(No re-link)
Re-link(ID set) and to
set the F/S position
No function
Re-link(ID set)
With 6EX, 7C,
TM-10, TM-14
Easy Link
Button


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Futaba R617FS at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Futaba R617FS in the language / languages: English as an attachment in your email.

The manual is 0,13 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info