587439
3
Zoom out
Zoom in
Previous page
1/19
Next page
Ge-3
Fig. 1 Innengerät
1 Bedienungsfeld (Fig. 2)
2 Taste für automatische Umschaltung
(MANUAL AUTO)
Wird die MANUAL AUTO-Taste länger als
10 Sekunden gedrückt gehalten, startet der
forcierte Kühlbetrieb.
Der forcierte Kühlbetrieb wird zum Zeit-
punkt der Installation verwendet.
Darf nur von autorisiertem Bedienungs-
personal verwendet werden.
Wenn der forcierte Kühlbetrieb auf irgend-
einem Grunde zufällig anläuft, drücken Sie
bitte die START/STOP-Taste, um den Be-
trieb auszuschalten.
3 Anzeige (Fig.3)
4 Fernbedienungs-Signalempfänger
5 OPERATION-Anzeigelampe (rot)
6 TIMER-Anzeigelampe (grün)
Wenn die TIMER-Lampe beim Betrieb des
Timers blinkt, bedeutet dies, daß eine feh-
lerhafte Timer-Einstellung vorliegt. (Lesen
Sie den Abschnitt “Automatische Wieder-
einschaltung” auf Seite 17.)
7 AIR CLEAN(LUFTREINIGUNGS)-Anzei-
gelampe (grün)
8 COIL DRY-Anzeigelampe (orange)
9 Einlaßgitter (Fig.4)
0 Luftfilter
A Luftleitlamellen-Führung
B Horizontal-Luftleitlamellen
(hinter Luftleitlamellen-Führung)
C Ablaßschlauch
D Elektrischer Luftreinigungsfilter
E Netzkabel
F Netzstecker
Fig. 5 Außengerät
G Lufteinlaß
H Luftauslaß
I Rohreinheit
J Kondensatablaß (Unterseite)
Fig. 6 Fernbedienung
K Signalgeber
L
Gesamtbetriebstaste (MASTER CONTROL)
M Gebläsedrehzahl-Wahltaste
(FAN CONTROL)
N START/STOP-Taste
O AIR CLEAN-Taste
P COIL DRY-Taste
Q SET-Taste
R SET TEMP.-Taste
(
/
)
S Taste für Schlafzeit-Timer (SLEEP)
T SWING-Taste
U TIMER MODE-Taste
V TIMER SET (
/
)-Tasten
W Testlauftaste (TEST RUN)
Diese Taste dient zur Überprüfung des
Klimagerätes nach der Installation und ist
bei normalem Betrieb nicht zu betätigen,
da die Thermostatfunktion des Klima-
gerätes anderenfalls nicht einwandfrei ar-
beitet.
Wird diese Taste während des normalen
Betriebs gedrückt, so schaltet das Gerät auf
die Test-Betriebsart um, und die Lampen
OPERATION und TIMER am Innengerät
beginnen gleichzeitig zu blinken.
Zum Beenden des Testbetriebs drücken Sie
die START/STOP-Taste um das Klimagerät
auszuschalten.
X CLOCK ADJUST-Taste
Y RESET-Taste
Z Anzeigefeld der Fernbedienung (Fig. 7)
[ Anzeige der Einstelltemperatur
\ Übertragungsanzeige
] Betriebsarten-Anzeige
^ Anzeige der Gebläsedrehzahl
a AIR CLEAN-Anzeige
b SWING-Anzeige
c COIL DRY-Anzeige
d Anzeige der Timer-Funktion
e SLEEP-Anzeige
f Anzeige für Zeiteinstellung
BEZEICHNUNG DER TEILE
Siehe die herausfaltbare Seite hinter dem vorderen
Einband.
3


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Fujitsu ASYB 09 LDC Plasma at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Fujitsu ASYB 09 LDC Plasma in the language / languages: German as an attachment in your email.

The manual is 0,44 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info