101068

Fujifilm Finepix 2800 ZOOM Manual

44
Zoom out
Zoom in
Previous page
1/49
Next page
8786
Problem Cause Remedy
Can’t use the flash to
take pictures.
i
The flash is set to Suppressed Flash
mode.
i
You pressed the shutter button while the
flash was charging.
i
The battery is exhausted.
i
Set the flash to Auto, Red-Eye Reduction
or Forced Flash mode.
i
Wait until charging is completed before
pressing the shutter button.
i
Replace the batteries.
The playback image is
too dark even though
the flash was used.
i
The subject is too far away.
i
Your fingers are obscuring the flash or
flash control sensor.
i
Move closer to the subject.
i
Hold the camera correctly.
The image is blurred.
i
The lens is dirty.
i
The lens is zoomed to telephoto in Macro
mode.
i
The photographed subject was too dark.
i
Clean the lens.
i
Cancel Macro mode.
i
Try standing about 2 m (6.6 ft.) from your
subject to take the picture.
There is speckling on
the image.
i
The shot was taken with a slow shutter
speed (long exposure) in a high-
temperature environment.
i
This is a characteristic of CCDs and
does not indicate a camera fault.
I can’t format the
SmartMedia.
i
The SmartMedia is write-protected.
i
Remove the write-protection.
Peel off the write-protect sticker)
The playback image is
faded when I used the
flash to take a picture.
i
There is dust on the flash control sensor.
i
Use an applicator such as a cotton swab
to clean the flash control sensor.
Troubleshooting eIf you think the camera is faulty, check the following once more
Problem Cause Remedy
No power.
i
The battery is exhausted.
i
The AC power adapter plug has come out
of the power outlet.
i
Replace the batteries.
i
Plug the adapter back in.
Power cuts out during
operation.
i
The battery is exhausted.
i
Replace the batteries.
Battery runs out quickly.
i
You are using the camera in extremely
cold conditions.
i
The terminals are soiled.
i
The battery is flat.
i
Put the battery in your pocket or another
warm place to heat it and then load it into
the camera just before you take a picture.
i
Wipe the battery terminals with a clean,
dry cloth.
i
Replace the batteries.
No photograph is taken
when the shutter button
is pressed.
i
No SmartMedia is loaded.
i
The SmartMedia is fully recorded.
i
The SmartMedia is write-protected.
i
The SmartMedia is not formatted.
i
The SmartMedia contact area is soiled.
i
The SmartMedia is damaged.
i
The Power Save function has switched
the camera off.
i
The battery is exhausted.
i
Load a SmartMedia.
i
Insert a new SmartMedia or erase some
unwanted frames.
i
Remove the write-protection.
i
Format the SmartMedia.
i
Wipe the SmartMedia contact area with
a clean dry cloth.
i
Load a new SmartMedia.
i
Switch the camera on.
i
Replace the batteries.
… 44 …


Need help? Post your question in this forum.

Forumrules
1

Forum

fujifilm-finepix-2800-zoom

Reset search

  • Which way to the batteries go in the camera but set up or upside Submitted on 23-12-2022 at 23:22

    Reply Report abuse


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Fujifilm Finepix 2800 ZOOM at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Fujifilm Finepix 2800 ZOOM in the language / languages: English as an attachment in your email.

The manual is 1,8 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info