337037
3
Zoom out
Zoom in
Previous page
1/10
Next page
3
Attentie: u dient niet alleen rekening te houden
met de omgevingstemperatuur voor dit type
product maar tevens met de volgende aanwijzin-
gen: wanneer de bewaartemperatuur onder de
aangeduide minimum waarde daalt, wordt de
bewaartemperatuur in het vriesvak niet meer
gegarandeerd; u kunt de bewaarde levensmid-
delen dan het beste zo snel mogelijk nuttigen.
Volg de raadgevingen van de fabrikant op met
betrekking tot waar en hoe u spijzen en dranken
bewaart of invriest. Ontdooide diepvriesproduc-
ten mogen, om gezondheidsredenen, niet
wederom ingevroren worden.
De vriezende binnenwanden of -vlakken in het
apparaat bevatten koelmiddel. Plaats geen
scherpe voorwerpen tegen zo’n wand of vlak en
schraap evenmin met metalen voorwerpen rijp of
ijs af. Lekkage kan het gevolg zijn, hetgeen een
onherstelbare schade aan het apparaat en bed-
erf van de levensmiddelen veroorzaakt.
Geen voorwerpen of methodes gebruiken om het
ontdooiproces te versnellen die niet door de fab-
rikant zijn aangegeven.
Nooit metalen voorwerpen gebruiken om het
apparaat schoon te maken; dit zou het apparaat
kunnen beschadigen.
Plaats geen koolzuurhoudende of mousserende
dranken in het vriesvak, het vriesgedeelte of de
vriezer; de blikjes of flesjes kunnen door bevriez-
ing van de inhoud exploderen.
Installatie
Overtuig u er van dat het apparaat niet op het
aansluitsnoer staat.
Belangrijk: Als de voedingskabel beschadigd
raakt, moet de kabel, eventueel met stekers, ver-
vangen worden; deze onderdelen zijn verkrijg-
baar bij de fabrikant of het servicecentrum.
Tijdens normaal gebruik worden de condensor
en de compressor die zich op de achterkant van
het apparaat bevinden, warm. Om veiligheidsre-
denen moet de ventilatie zodanig zijn als
aangegeven in de speciale Figuur.
Attentie: zorg ervoor dat de ventilatie-openin-
gen tijdens gebruik niet worden afgedekt.
Plaats het apparaat met z’n achterkant zo dicht
mogelijk bij een muur. Hiermee voorkomt u ver-
brandingsletsel door aanraking van hete tot zeer
hete delen.
Afhankelijk van de wijze van transport kan olie
vanuit de compressor in het koelcircuit gevloeid
zijn. Wacht, na het plaatsen van het apparaat,
ten minste een half uur alvorens de steker in het
stopcontact te steken. Na achteroverliggend ver-
voer ten minste een halve dag. Daarmee geeft u
de olie de gelegenheid in de compressor terug te
vloeien. Apparaten welke van een absorptie-unit
voorzien zijn kunnen direct in bedrijf genomen
worden. Controleer circa 24 uur na het in bedrijf
stellen of het apparaat naar behoren werkt.
Milieubescherming
Belangrijk: Dit apparaat bevat, zowel in het koel-
circuit als in de isolatie, geen ozononvriendelijke
stoffen. Het apparaat moet niet weggegooid wor-
den samen met het huisvuil of met gesloopte
apparaten. Vermijden dat het koelcircuit wordt
beschadigd, vooral aan de achterkant in de zone
van de warmtewisselaar. Inlichtingen over
ophaaldiensten kunnen worden verschaft door de
gemeentelijke autoriteiten. De materialen in dit
apparaat die voorzien zijn van het symbool
zijn geschikt voor recycling.
18
Electrical connection
Before plugging in, ensure that the voltage and fre-
quency shown on the serial number plate corre-
spond to your domestic power supply. Voltage can
vary by ±6% of the rated voltage.
For operation with different voltages, a suitably
sized auto-transformer must be used.
The appliance must be earthed.
The power supply cable plug is provided with a con-
tact for this purpose.
If the domestic power supply socket is not earthed,
connect the appliance to a separate earth in compli-
ance with current regulations, consulting a specialist
technician.
The Manufacturer declines all responsibility if
the above safety precautions are not observed.
This appliance complies with the following
E.E.C. Directives:
- 87/308 EEC of 2/6/87 relative to radio interference
suppression.
- 73/23 EEC of 19.2.73 (Low Voltage Directive) and
subsequent modifications;
- 89/336 EEC of 3.5.89 (Electromagnetic
Compatibility Directive) and subsequent modifi-
cations.
INSTALLATION
Location
The appliance should be installed well away from
sources of heat such as radiators, boilers, direct
sunlight etc.
For safety reasons, minimum ventilation must be as
shown in Fig.
Appliance positioned under overhanging kitchen
wall units (see Fig. A).
Appliance positioned without overhanging kitchen
wall units (see Fig. B).
Attention: keep ventilation openings clear of
obstruction.
Two adjustable feet at the cabinet base allow accu-
rate levelling of the appliance.
NP002
100 mm10 mm
10 mm
A
B
PR60
A
45°
Rear spacers
In the bag with the documentation, there are two
spacers which must be fitted in the two top cor-
ners.
Fit the spacers into the holes, taking care to ensure
that the arrow (A) is positioned as shown in figure.
Then turn them through 45° (arrow (A) vertical) until
they lock into place.
3


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Frigidaire fr 250 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Frigidaire fr 250 in the language / languages: Dutch as an attachment in your email.

The manual is 0,15 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info