Manual First Degree EVOLUTION E920 MEDICAL UBE (page 19 of 22) (English)

671487

Zoom out

Zoom in

1/22

Troubleshooting

Fault Probable Cause Solution

Water changes color

or becomes cloudy.

Rower is in direct

sunlight or has not

had water treat-

ment.

Change rower location to reduce direct

exposure to sunlight. Add water treatment

or change tank water as directed in the

water treatment section of this manual.

Consider using distilled water to refill tank.

Knocking noise from

inside the control

arm while training,

especially when

changing directions.

Chain requires

tightening or

adjustment.

Open inspection plate located on front of

control arm and check tension using a

screwdriver or other tool. Use the chain

tensioning bolts located at the rear of the

control arm to tighten or adjust as

needed. The chain should have approx 3mm

of slack when properly adjusted. See P.7

for details.

Handle slip during

hard training.

PK tank belt

requires

tightening.

Remove large inspection plate next to the

tank, insert a long tool to push the rear

end cap out from the inside, exposing the

Tank Belt Tensioning Bolt. Loosen tank

bolts slightly. Remove upper rubber belt

cover to expose the PK belt. Tighten the

Tank Tensioning Bolt until the Belt is too

tight to be twisted from side to side more

than 45 degrees by hand. See P.17/18 for

details

Handle is loose

(either left or right)

and cannot be

retightened.

Aluminum crank

arm threads are

stripped.

Contact service center for replacement.

Then check weekly as recommended.

IPM screen

illuminates, but does

not register when

rowing.

Loose or failed

connection/Sensor

gap too wide (see

erratic computer

display).

Check that the computer lead is connected

properly. If connected properly check

sensor gap. Contact your local service

center if this fails to address the problem.

IPM does not

illuminate after

battery installation.

Batteries installed

incorrectly or need

replacing.

Reinstall batteries in correct position and

try again. If the LCD screen fails to

illuminate, try rotating the batteries

slightly in the computer. If this fails,

contact your local service center.

IPM is erratic/slow

while displaying RPM

and WATTS

Gap between

sensor and

magnetic ring is

too wide.

Remove inspection plate and check sensor

gap and that magnetic ring is not wobbly.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of First Degree EVOLUTION E920 MEDICAL UBE in the language / languages: English as an attachment in your email.

The manual is 3,99 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

First Degree EVOLUTION E920 MEDICAL UBE Manual

Product: