637207
1
Zoom out
Zoom in
Previous page
1/4
Next page
Gebrauchsanweisung Fahrrad-Computer 40.117
Bitte lesen Sie die folgenden Anweisungen sorgfältig durch.
FUNKTIONEN:
- SPD Geschwindigkeit - autom. Anzeigenwechsel
- ODO Gesamtstrecke (0,001-99999km/m) - autom. Aus/Standby
- DST Tagesstrecke - Einstellung km/h oder m/h
- MXS Höchstgeschwindigkeit - Geschwindigkeitsvergleich
- AVS Durchschnittsgeschwindigkeit - Radgrößeneinstellung (0mm-9999mm)
- TM Fahrtzeit - Voreinstellung Gesamtstrecke / ODO
- CLK Uhr (12H/24H) - Einstellung Körpergewicht
- TMP Temperatur (-10 - +70°C) - Anzeige ausblenden
- CAL Kalorienzähler (0-99999Kcal) - Wartungsanzeige
- FAT Fettverbrennung (0-9999.9kg) - „ “ Batterie-Anzeige
- min. Temperaturanzeige - Display-Beleuchtung
- max. Temperaturanzeige - autom. Start/Stop
1. EINLEGEN DER BATTERIE:
Abdeckung vom Batteriefach an der Unterseite des
Computers mit einem Schlitzschraubendreher ab-
nehmen und die CR2032-Batterie einlegen; Plus-
pol (+) sichtbar oben, Batteriefachabdeckung wie-
der aufsetzen und verschließen. Sollte die LCD-
Anzeige nicht funktionieren, Batterie entnehmen
und erneut einlegen.
2. SENSOR:
Sensorhalterung am linken Gabelblatt montieren
und mit Kabelbindern (siehe unten) an der Gabel
befestigen. Sensor und Magnet entsprechend Ab-
bildung anordnen. Dabei darauf achten, dass der
Bogen des Magnets die
Justiermarke am Sensor
mit 1 mm Abstand schneidet.
3. COMPUTERHALTERUNG:
Die Computerhalterung mit beiliegendem Kabel-
binder sicher an der Lenkstange befestigen.
4. FAHRRADCOMPUTER:
Computer an die Halterung montieren. Dazu den
Computer aufdrehen, bis er sicher einrastet. Zum
Abnehmen des Computers, den Computer in die
entgegengesetzte Richtung drehen. Zur Kontrolle
der ordnungsgemäßen Funktion und der Anbrin-
gung von Sensor und Magnet, das Vorderrad bei
aktiviertem Computer drehen. Stellung des Sensors
und Magneten bei fehlender oder ungenügender
Anzeige korrigieren.
Sensor
Kabelbinder
Sensor
Magnet
Computer
1


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Filmer 40.117 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Filmer 40.117 in the language / languages: German as an attachment in your email.

The manual is 0,4 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info