510139

Ferm TJM1008 Manual

2
Zoom out
Zoom in
Previous page
1/40
Next page
EN
2 Ferm
TROLLEY JACK
Carfully read the instructions before you
use the trolley jack!
Contents
1. Machine data
2. Safety instructions
3. Operation
4. Maintenance
1. Machine data
Technical specification
Carrying capacity 2000 kg
Lifting height (min/max) 135/356 mm
2. Safety instructions
The following symbols are used in these
instructions for use:
Denotes risk of personal injury, loss of life
or damage to the machine in case of non-
observance of the instructions in this
manual.
Make sure the oil level is correct
Special safety rules
Non-observance of the following
instructions can cause personal injuries
and/or damage to the vehicle.
• Placethesaddleofthejackonlyinthespot
designed for this purpose. For the relevant
jackingpointspleaserefertoyourcar
instructions.
• Themaximumloadindicatedonthejackmust
never be exceeded.
• Thejackmustbeusedasaliftingdeviceonly.
• Alwaysplacethejackonahardandlevel
surface.
• Alwaysprotectthecarfromrollingaway.
Beforejackingupthecar,placechocksbehind
and in front of the wheels remaining on the
ground,ifnecessary.Putthecarinfirstgearor
put on the handbrake to further block the car.
• Makesuretoplacethejackinsuchawaythat
your hand is not underneath the car when
jackingitup.
• Makesurethejackishorizontal.
• Foryourownsafety,beforeworkingor
crawlingunderneaththecarjackupthecar
and support the shafts.
• Beforeusingtheshaftsupportsmakesure
they are in good condition.
3. Operation
Lifting
Turn the screw of the relief valve clockwise as far
aspossible.Thetrolleyjackisnowreadytolift.
Putthetrolleyjackhorizontallyonaflatsurface,
put the lever in the proper hole and start pumping
by moving the lever up and down.
Shaft supports
Afterjackingupthecartheshaftsupportsshould
be installed. Lower the car by turning the the
screwofthereleasevalveanticlockwise,untilthe
car rests on the supports. Never work under a car
whichonlyrestsonthetrolleyjack.
Lowering
Aftertheworkisfinished,thecarisliftedagain
until the shaft supports are clear. Remove the
shaft supports. Turn the screw of the relief valve
anticlockwise and the car will be lowered. The
further the screw is turned anticlockwise the faster
the car will be lowered.
4. Maintenance
Regular maintenance of your trolley jack
prevents problems!
• Onceamonththewheels,shaftsandpiston
rods should be lubricated with lubricating oil
and grease on the pivots of the lifting rods.
• Thetankcontaininghydraulicoilisaclosed
tank which usually does not require
maintenance.Whenfrequentlyused,butat
leastonceayear,theoilshouldbechanged.
For this purpose the top of the tank is fitted
with an oil drain plug.
Only hydraulic oil should be used for
refilling. Do not use engine or brake fluid.
2 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Ferm TJM1008 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Ferm TJM1008 in the language / languages: English, German, Dutch, Danish, French, Italian, Polish, Portuguese, Swedish, Spanish, Norwegian, Finnish as an attachment in your email.

The manual is 1,37 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info