Manual Fender 65 Twin Custom 15 (page 7 of 20) (English)

442904

Zoom out

Zoom in

1/20

M. POWER CORD - Connect the power line cord to a

grounded AC outlet in accordance with the voltage

and frequency ratings listed on the rear panel of your

amplifier.

N. FUSE - Replace a failed fuse ONLY with the type and

rating as labeled on the fuse holder.

O. POWER - Switches the amplifier on and off.

P. STANDBY - Use STANDBY during short breaks

instead of switching the amplifier off . By doing this

you avoid the warm-up delay upon returning to play

and you extend the life span of your tubes. Using

STANDBY for 30 seconds when first switching the

amplifier on will also extend tube life span.

Q. SPEAKER - Main speaker connection. A speaker

must ALWAYS be connected at this jack when the

amplifier is on to prevent damage to the amplifier.

R. EXTERNAL SPEAKER - Connection for an external

speaker. Only plug an 8-ohm speaker into this jack

when there is another 8-ohm speaker connected to

the main SPEAKER jack.

S. FOOT PEDAL - Connect the included foot pedal

here to enable remote on/off switching of Reverb and

Vibrato.

wwwwww

ffeennddeerr..ccoomm

✧

wwwwww

..mmrrggeeaarrhheeaadd..nneett

If the sound quality of the amp has degraded noticeably the tubes may be worn and need replacement. Output tubes

typically need replacement before pre-amp tubes. If you are not sure about the condition of your tubes or the following

procedures, take your amplifier to an authorized Fender Service Center. Replace tubes with identical Fender® original

equipment only (see SPECIFICATIONS below). Tube location is printed on the tube label, inside the cabinet.

T. HUM BALANCE ADJUSTMENT - This adjustment minimizes the hum heard at the speakers due to tube filament

imbalance. •Adjustment Instructions: Turn the amplifier ON for 2 minutes with nothing plugged into any of the

INPUTS. Rotate the Vibrato channel VOLUME, MIDDLE, and BASS knobs fully clockwise and the TREBLE knob

fully counter-clockwise. Rotate ALL of the Normal channel knobs fully counter-clockwise. Switch OFF the

REVERB and VIBRATO effects. Insert a slotted screwdriver into the BALANCE ADJUSTMENT control {T} and

rotate back and forth to the position with the least amount of hum.

U. BIAS ADJUSTMENT - This adjustment should be made only by an authorized Fender Service Center. BIAS

needs adjustment only if the replacement output tubes are not identical to the original tubes.

CHASSIS

BOTTOM

VIEW

POWER RATING

260 WATTS

FUSE

POWER STANDBY

SPEAKER EXT.

SPEAKER

FOOT

PEDAL

TYPE: PR 186

PART NUMBER: 21-73000-010 (120V, 60Hz) USA, 21-73001-010 (110V, 60Hz) TW, 21-73003-010 (240V, 50Hz) AUS

21-73004-010 (230V, 50Hz) UK, 21-73005-010 (220V, 50Hz) ARG, 21-73006-010 (230V, 50Hz) EUR

21-73007-010 (100 V, 50 Hz) JPN

POWER REQUIREMENTS: 260 watts

POWER OUTPUT: 85 watts R.M.S.

IMPEDANCES: INPUTS 1: 1M ohm (both channels),

INPUTS 2: 136k ohms (both channels)

OUTPUT: 4 ohms (both speaker jacks together)

SPEAKER: One 15 in, 4-ohm cast-frame Fender Special Design driver made in USA by Eminence

(P/N-064398)

TUBES: OUTPUT: Four Fender Special Design 6L6GC’s (P/N-039214),

PRE-AMP: Four Fender Special Design 12AX7A’s (P/N-013341),

Two Fender Special Design 12AT7’s (P/N-023531)

INCLUDED EXTRAS: Footswitch for Vibrato and Reverb, removable casters and cover

DIMENSIONS: HEIGHT: 22 in (55.9 cm)

WIDTH: 26.15 in (66.4 cm)

DEPTH: 10.5 in (26.7 cm)

WEIGHT: 64 lb (34 kg)

Product specifications are subject to change without notice.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Fender 65 Twin Custom 15 in the language / languages: English as an attachment in your email.

The manual is 1,67 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Fender 65 Twin Custom 15 Manual

Product: