502657
5
Zoom out
Zoom in
Previous page
1/76
Next page
WARRANTY
Fellowes warrants all parts of the binder to be free of defects in material and workmanship for
2 years from the date of purchase by the original consumer. If any part is found to be defective
during warranty period, your sale and exclusive remedy will be repair or replacement, at Fellowes’
option and expense, of the defective part. This warranty does not apply in cases of abuse, mishan-
dling or unauthorised repair. Any implied warranty, including that of merchantability or tness for
particular purpose, is hereby limited in duration to the appropriate warranty period set forth above.
In no event shall Fellowes be liable for any consequential damages attributable to this product.
This warranty gives you specic legal rights. You may have other legal rights that vary from this
warranty. The duration, terms and conditions of this warranty are valid worldwide, except where
different limitations, restrictions or conditions may be required by local law. For more details or to
obtain services under this warranty, please contact Fellowes or your dealer.
5
CORRECTING A BOUND DOCUMENT
Additional sheets may be include or removed at any time by opening and then closing the comb as previously described.
REMOVAL OF WASTE CLIPPINGS
The waste tray is located under the machine and is accessed from the right side. For best results empty the tray regularly.
STORAGE
Switch off the machine. Lower the lid. The Pulsar-E comb binder is designed to be stored horizontally on the desk.
TROUBLESHOOTING
Problem
No Green power neon
Red standby neon
Punched holes are not central
Machine will not punch
Punch holes are not parallel to edge.
Waste tray leaks
Partial holes
Damaged hole edges
Waste tray leaks
Cause
Machine is not switched on
Machine is overloaded when punching
Edge guide not set
Blockage
Debris is stuck below dies.
Waste tray is not correctly inserted or ‘burst feature’ has activated
Sheets not correctly aligned to punch pattern.
Possibly overloading the machine
Waste tray is not correctly inserted or ‘burst feature’ has activated
Solution
Switch on machine at rear next to plug inlet and at the socket.
Press the punch button. The machine will withdraw the punches and re-set
itself. Continue this process until the punch cycle is complete
Adjust edge guide until hole pattern is correct
Check waste tray is empty. Check for blockage to paper entry.
Take stiff cardboard and slide into the paper entry. Move the cardboard
sideways to release any stray clippings into the waste tray.
Check waste tray is empty and ‘burst feature’ is closed.
Adjust edge guide and test punch scrap sheets until correct
Punch plastic covers with paper sheets. Reduce number of sheets being
punched.
Check waste tray is empty and ‘burst feature’ is closed.
Need Help?
Customer Service….
www.fellowes.com
Let our experts help you
with a solution.
Always call Fellowes
before contacting
your place of purchase.
5


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Fellowes Pulsar E300 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Fellowes Pulsar E300 in the language / languages: English, German, Dutch, Danish, French, Italian, Polish, Portuguese, Swedish, Turkish, Spanish, Norwegian, Finnish as an attachment in your email.

The manual is 15,57 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info