784936
21
Zoom out
Zoom in
Previous page
1/24
Next page
18
DRAINING OR WINTERIZING
Every three to six months, depending upon the
water condition, you need to renew your water.
CAUTION: READ THIS BEFORE DRAINING
YOUR SPA
To prevent damage to the spa’s components,
TURN OFF SUBPANEL BREAKER BEFORE
DRAINING. Do not power back up until your
spa has been refilled with water.
There are certain precautions to keep in mind
when draining your spa. If it is extremely cold,
and the spa is outdoors, freezing could occur
in the plumbing or the equipment.
Do not leave the spa's shell (inside surface)
exposed to direct sunlight.
DRAINING YOUR SPA
If draining for the first time, pull the hose bib
out a few inches from the spa (located in
the recess under the spa, to the side of the
equipment access door).
Unscrew and remove the drain cap.
Attach hose bib to a garden hose and direct to
an appropriate draining area, keeping the hose
below the water
line.
After your spa
is empty, clean
the shell and
filter cartridge.
See “Spa
Maintenance”
section.
After cleaning, remove garden hose, replace
drain cap and push the hose bib back into the
recess.
Follow the “Fill up and Start-up Instructions” on
page 14.
WINTERIZING YOUR SPA
If you plan to store your spa for the winter, you
must also use a wet-vac to clean out the water
lines to ensure they are free of any water. Water
left in the lines might freeze and damage the lines
and jets.
1. It will be necessary to remove all water from
the interior plumbing.
2. Remove the floating weir, basket, and filter
cartridge. Clean the filter cartridge and store
in a dry place. Attach the vacuum hose to the
vacuum side of the shop vac and thoroughly
dry the filter compartment.
3. Using the shop vac, remove the water starting
with the jets at the top and moving to the
ones at the bottom of the spa. NOTE: When
removing the water from jet openings, you
may notice suction coming from another jet.
With the help of a second person, block off any
suction from the other jet using a large rag or
cloth. This will help pull out the water that is
trapped deep inside the main line.
4. Thoroughly dry the spa shell with a clean
towel.
5. Using a funnel, pour Propylene glycol anti-
freeze into the filter suction fittings and jet
outlets. CAUTION: Use only Propylene
glycol as your anti-freeze. This is non-toxic.
NEVER use automobile anti-freeze since it
is toxic.
6. Remove the pump drain plug located on the
front of the pump housings. Allow all water to
drain out. Place the drain plug in a reclosable
plastic storage bag and store near the pump.
Replace the drain plugs on start-up.
7. Unscrew the suction/discharge pump and
heater unions and allow the water to drain.
Leave union loose.
NOTE: Tighten unions before filling spa.
8. Replace the equipment compartment door and
secure with screws.
NOTE: Damage caused by improper
winterizing will not be covered under warranty.
You may want to contact your local Dealer for
proper winterizing.
21


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Fantasy Embrace 2019 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Fantasy Embrace 2019 in the language / languages: English as an attachment in your email.

The manual is 0.56 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info