Manual Faber Opti-V Fire PGF10 (page 8 of 12) (English, German, Dutch, French, Norwegian)

706570

Zoom out

Zoom in

1/12

Contents of Carton

• Opti-V Fire Model PGF10

• Remote control and batteries (AAA type)

Important Safety Advice

When using electrical appliances, basic precautions should

be followed to reduce the risk of ﬁ re, electric shock, and

injury to persons, including the following:

If the appliance is damaged, check immediately with the

supplier before installation and operation.

Do not use this appliance in the immediate surroundings of

a bath, shower or swimming pool.

Means for disconnection must be incorporated in the ﬁ xed

wiring in accordance with the wiring regulations.

Do not use outdoors.

In the event of a fault switch off the appliance.

Switch off the appliance when not required for long periods.

If the supply cord is damaged, it must be replaced by a

special cord or assembly available from the manufacturer

or its service agent.

Warning - No naked ﬂ ame sources, such as candles, should

be placed on this apparatus.

Warning - The appliance shall not be exposed to dripping

or splashing and that no objects ﬁ lled with liquid, such as

vases, shall be placed on the apparatus.

Warning - this appliance is of Class I construction and must

be connected to a mains outlet with protective earthing

connection.

Electrical

WARNING – THIS APPLIANCE MUST BE EARTHED

Do not switch the appliance on until properly installed. Please

read all the safety warnings and operating instructions.

Installation

Warning.

Do not connect the appliance until properly ﬁ xed to a secure

base and the instruction leaﬂ et is read fully.

At installation of the appliance, care must be taken not to

damage any cables that may be concealed in the wall.

Please be careful while drilling the holes.

These models are designed to be permanently fixed

for optimum viewing of the display screen see Fig.2a and 2b.

Dimensions indicated * are recommended ﬁ xing dimensions

from ﬂ oor to underside of the wall aperture - 65cm for viewing in

a seated position and 110cm for viewing in a standing position.

The outline of the chassis and the position of the electrical

socket are shown as dotted outlines in Fig.4. Please consult

with a qualiﬁ ed electrician for appropriate wiring requirements.

Operation: -

The power ‘ON’ switch (‘O/I’see Fig.3) must ﬁ rst be switched

‘I’ to operate the appliance.

The ‘Opti-V’ logo will appear for about 3 seconds before the

ﬂ ame picture starts.

Note: The user may notice a blank screen for approximately

5 seconds, every 30 minutes. This is normal and should not

be a cause for concern.

Opti-V Fire : PGF 10

IMPORTANT: THESE INSTRUCTIONS SHOULD BE READ CAREFULLY AND RETAINED FOR FUTURE REFERENCE

Manual Control Operation: -

The manual controls for the screen are located at the inner top

left hand side of the appliance above the glass.(see Fig.3).

The appliance Power switch (‘O/I’ see Fig.3) may be used

to switch the appliance off (‘O’) when it is not required, for

example, overnight or for long periods, to avoid energy

wastage.

The standby button ( ) is located just below the mains switch.

Remote Control Operation: -

The remote control may be operated once the appliance is

switched ‘I’ (‘I’ see Fig.3). A red light will indicate when the

appliance is in standby mode. (See Fig.4) Aim the remote

control at the screen (I.R. sensor is indicated in Fig. 4). The

audio volume may be adjusted up or down by pressing the

volume control buttons ( + and -). For installing or replacing

the AAA batteries into the remote control - see Fig. 5.

NOTE - Use Alkaline batteries only.

Batteries should not be exposed to heat such as sunshine,

ﬁ re and the like.

Attention should be drawn to the environmental aspects of

battery disposal.

Maintenance

WARNING – ALWAYS DISCONNECT FROM THE POWER

SUPPLY BEFORE ATTEMPTING ANY MAINTENANCE.

To disconnect from mains - set the mains switch to ‘O’. The

mains (power) switch is located at the top left hand side of the

appliance above the manual controls - see ‘O/I’ Fig.3.

Mians switch shall remain readily operable.

Techical Information:

100-240V ~ 50/60Hz

Power consumption 32W

Stand-by Power 1W

Cleaning

For general cleaning use a soft clean duster – never use

abrasive cleaners. The glass screen should be cleaned

carefully with a soft cloth. DO NOT use proprietary glass

cleaners.

Warranty and Service

For service and warranty of the product log onto the website

http://www.gdbservice.com/

select Faber and select ‘Electric’. Select model Opti-V Fire

PGF10. The series number of the product can be found on

the label on the right hand side of the product above the glass.

Please retain your receipt as proof of purchase.

Recycling

For electrical products sold within the European Community.

At the end of the electrical products useful life it

should not be disposed of with household waste.

Please recycle where facilities exist. Check with

your Local Authority or retailer for recycling advice

in your country.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Faber Opti-V Fire PGF10 in the language / languages: English, German, Dutch, French, Norwegian as an attachment in your email.

The manual is 0,27 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Faber Opti-V Fire PGF10 Manual

Product: