Manual Ezetil E40 (page 4 of 78) (English, German, Dutch, Danish, French, Italian, Polish, Portuguese, Swedish, Turkish, Spanish, Norwegian, Finnish)

513634

Zoom out

Zoom in

1/78

4 GB

Operation / Tips for the best cooling ... / Exchanging the 12 V fuse / Possible malfunctions / Cleaning and care / Warranty

avoids temperature control by means of the constant on / oﬀ switching of tra-

ditional refrigeration technology, which causes a high level of material wear.

If you wish to achieve a colder inside temperature in the coolbox, brieﬂy

press the ‘boost switch’ (the blue LED lights up if the the ‘boost function’ is

switched on). By doing this, you exit the ‘eco function’ (normal operation)

and the power supply is automatically switched to the maximum cooling

output. Since with thermoelectric coolboxes the refrigeration temperature is

always dependent on the ambient temperature around the coolbox, the cool-

ing unit always produces an inside temperature when the ‘boost function’ is

switched on, which is up to 18 °C lower than the particular outside tempera-

ture of the coolbox (example: outside temperature 24 °C = inside temperature

approx. 6 °C). Please be aware that – during the ‘boost function’ – freezing

of the coolbox contents can occur at low outside temperatures.

The ‘boost function’ is set at the factory in such a way that after 24 hours

operation it automatically switches to the power-saving normal operation

(= automatic inside temperature between 8 °C and 14 °C). To switch the ‘boost

function’ oﬀ earlier, press the ‘boost switch’ again (the blue LED goes out).

Function with 12 V operation

Please note:

When the coolbox is operating with a 12 V power supply, the cooling unit

always produces a temperature diﬀerence from the ambient temperature of

up to 18 °C. The ‘boost switch’ only functions in 230 volt operation; with

12 volt operation the ‘boost switch’ does not display any function!

Tips for the best cooling

output and energy saving

Select a well ventilated location protected from sunshine.

Only place pre-cooled contents into the coolbox.

Do not open the coolbox longer than necessary.

Don’t leave the lid open longer than necessary.

Ensure that the coolbox is not packed too full and that the air can

circulate adequately between the coolbox contents.

In order that a high level of energy saving can be achieved, normal op-

eration (no ‘boost function’) is recommended for longer periods of use in

230 V operation.

Exchanging the 12 V fuse

To exchange the fuse

, ﬁrst remove the red adapter

from the plug.

Unscrew the screw

with a suitable Phillips screwdriver from the top

half of the housing

Lift the top half of the housing from the bottom half

Note: Hold the contact spring tightly

while you remove the fuse.

Otherwise the contact spring can jump out.

Lift the contact pin

carefully out of the housing section. The fuse can

now be removed.

Note: if the thin metal connection in the middle between the two metal

caps is broken, then the fuse is defective and must be replaced.

Press the contact spring backwards and insert the new fuse carefully into

the groove provided for it. Now place the rear edge of the contact pin

on the front metal cap of the fuse. By releasing the contact spring, the

fuse and contact pin are located in the groove.

Screw the top and bottom halves of the housing together again, place

the red adapter

back on and tighten this again. The plug is now

ready for operation.

46 5

Possible malfunctions

Firstly check whether you have correctly followed the instructions for using the

coolbox, then also check:

– Is the connection cable correctly connected and does your car cigarette

lighter / domestic socket function properly?

– Have you set up the coolbox in such a way that the air can circulate

freely and that venting of the cooling unit can occur?

– Is the fuse in the plug of the 12 V connection cable OK?

If you can not rectify the malfunction on your own, please contact our

Customer Service (see chapter on “Service centre”).

Cleaning and care

Do not use any abrasive cleaning agents. If you do, there is a risk of

damage to the product.

Before any cleaning, pull the plug of the connection cable out of the

socket or of the cigarette lighter. Otherwise there is a risk of electric

shock.

Never clean the coolbox under running water. If you do, this could result

in damage to the electrics.

Before cleaning, remove the electrical lid by pulling it out at a slight angle

from the right rear recess.

Use a dry cloth for cleaning the electrical lid.

Use a damp cloth and a mild soap solution for cleaning the bottom

section of the coolbox.

Use clean water to rinse oﬀ those parts cleaned with soapy water.

Warranty

The warranty for this appliance is for 2 years from the date of purchase.

Where there are defects in this appliance, you have statutory rights available

against the seller of the appliance. Your statutory rights are not restricted in

any way by our warranty as detailed below.

Warranty conditions:

The warranty period begins on the date of purchase. Please retain the original

receipt safely. This receipt is required as proof of purchase.

Should this appliance show any fault in materials or manufacture within 2 years

from date of purchase, it will be repaired or replaced – at our choice – by us

free of charge. This warranty is conditional on the defective appliance and

the receipt of purchase being presented within the 2 year warranty period,

and that there is a brief written description of the nature of the defect and of

the date it arose.

If the defect is covered by our warranty, you will receive the repaired appli-

ance back or a new appliance. A new warranty period does not commence

with the repair or with the exchange of the appliance.

Cooler operates fine when plugged in inside. Will not work when plugged into vehicle Submitted on 11-10-2022 at 16:11
Reply Report abuse

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Ezetil E40 in the language / languages: English, German, Dutch, Danish, French, Italian, Polish, Portuguese, Swedish, Turkish, Spanish, Norwegian, Finnish as an attachment in your email.

The manual is 1,42 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Ezetil E40 Manual

Product: