10 11
allow for the evaporation of moisture possibly
present in the device.
Short-term storage:
You may use the carrying box, when you want
to remove the device from the ear temporarily.
Long-term storage:
When you do not use your Qleaf Go over a
longer period of time, clean the module and
soft tip before storing them inside the carrying
box. Always remove the battery from the
device in this situation.
Trouble shooting
If your Qleaf Go makes a whistling sound
regularly, make sure that:
1 the correct size of soft tip has been used
2 the module has been inserted properly in
the soft tip and
3 Qleaf Go has been inserted properly and
far enough into the ear.
If you wear your soft tips too long, the material
could deteriorate and loose its seal. In that case
replace the soft tip with a new one. It is normal
if the Qleaf Go makes a whistling sound if you
place it in the ear.
If you can not hear any sound from the
Qleaf Go, it is possible that:
1 the battery is dead. Battery life depends
very much on the wearing time. If you
wear the Qleaf Go approximately 16 hours
a day, you should at least have 4 days of
battery life. Bare in mind that a cell battery
always draws power after removing the
sticker, even when not used in a device!
2 the sound opening of the soft tip is blocked
with ear wax. If this is the case clean the
soft tip (see chapter ‘Maintenance and use
- Cleaning’) or replace it.
Important
• Do not adjust the volume level too high.
• Do not use the Qleaf Go in very loud
three beeps will be audible indicating that
program three has been activated. While
program four is active, after a gentle tap one
beep becomes audible and the device sets
back to program one.
Cleaning
The production of ear wax diers from one
person to another. Therefore it cannot be
avoided completely that the sound outlet of
the soft tip will be clogged with ear wax.
Although the sound volume may reduce
because of clogging, this should normally not
damage your device. In case you observe that
the sound outlet of the soft tip has been
clogged, you may clean the soft tip (see
paragraph ‘Cleaning’) or replace it.
Module:
• Clean daily with a soft and dry tissue.
• In case of severe dirt, wipe with special
(moist) cleaning tissues.
Soft tip:
• Clean daily with a soft and dry tissue.
• In case of severe dirt, you may clean it with
special (moist) cleaning tissues.
• Clogged soft tips can be rinsed o under
streaming lukewarm water after removing
the Qleaf Go module. In case of severe or
persistent dirt or if a change in the
properties or damage of the material
occurs, the soft tip should always be
replaced.
Never use aggressive cleaning products,
abrasives or solvents! This can cause irrevocable
damage to the soft tip or the module.
Storage
At night:
We recommend that you remove the soft tip
from the module during the night: Remove the
battery from the device and store it in a secure
place outside its box. In this way, you increase
the operational life of the battery and also