2714
34
Zoom out
Zoom in
Previous page
1/38
Next page
Table
If the appliance does not work properly,
this does not always mean that it is
defective. Try to deal with the problem
yourself first.
Phone the service department if the
advice given below does not help. Only
authorised personnel may open the
appliance or carry out work on the mains
power supply.
Damage caused by incorrect connection,
incorrect installation or incorrect use is
not covered by the warranty.
In the case of faults visit the internet site
www.hps.nl.
Fault
Cooking zones do not get hot.
Error codes F00-F12 in the
display.
Error code F3 appears.
Error code F99 appears.
Spontaneous change of
setting selected.
Cause
– Appliance incorrectly
connected.
– Plug not, or not completely, in
the socket.
– Fuse(s) in the meter cupboard
defective.
– A button is defective or dirty or
there is an object on top of it.
Each button has its own
number, from 00 to 12. The
number associated with the
button appears in the display.
– Transistors overheated.
– The appliance has insufficient
ventilation.
– Two or more buttons were
operated for a long time.
– Pan too close to buttons.
Solution
– See the installation
instructions for correct
connection.
– Put the plug into the socket
– Check the fuses in the meter
cupboard.
– Clean the appliance. Do not
place any objects on the
control panel.
– Allow the appliance to cool
down until the code
disappears.
– Make sure there is sufficient
ventilation.
– Do not operate more than one
button at the same time.
– Make sure that pan is at least
20 mm from buttons.
67 FAULTS
66
MAINTENANCE
General
Clean the cooking appliance after each use.
You can use a mild cleaning agent for this - for
example, washing-up liquid. Always clean the
hobs after use. You can use a mild cleaning
agent, such as washing-up liquid, for this
purpose. Special cleaning agents for ceramic
hobs have the advantage that a thin film
remains on the glass surface so that over-
cooked food and lime scale are less likely to
get burnt into the hob, making it easier to
clean the next time.
It is best to let the hob cool down before
cleaning it. Over-cooked food containing a lot
of sugar and acids, such as apple sauce,
rhubarb or red cabbage are best removed
immediately with a damp dish cloth to prevent
them getting burnt into the hob. Be careful
with the hot cooking zone!
You can use a glass-scraper to remove
obstinate food residue.
Traces of metals (due to sliding pans) can be
difficult to remove.Special products are
available for removing traces of metal.
Never use
You should never use scouring agents. These
cause scratches in which lime deposits and
dirt can accumulate.
Never use sharp objects such as steel wool
and scourers.
For cleaning tips refer to the internet site
'www.hps.nl'.
34


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Etna T265 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Etna T265 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 1,05 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info